New batteries new Solenoid Still no Power

[Shuga]

Originally Posted by kgsc

I can’t tell from that picture but if you have voltage at pin 4 you are good. At this point I would check all the switches and make sure they are working. You can do that at the plugs. Put it in tow before you unplug them.

What switches should I be testing? And the same plug?


Sent from my iPhone using Tapatalk

[kgsc]

Run tow, key switch, foot pedal switch, FnR

[Bama Brad]

This may not be the problem, but looking at your wires....they look very old and corroded. I would redo the ends at least to make certain that is not a problem before you start replacing/guessing at more expensive parts.

[Shuga]

Originally Posted by kgsc

Run tow, key switch, foot pedal switch, FnR

So I get the voltage from the pins again?


Sent from my iPhone using Tapatalk

[Shuga]

Originally Posted by Bama Brad

This may not be the problem, but looking at your wires....they look very old and corroded. I would redo the ends at least to make certain that is not a problem before you start replacing/guessing at more expensive parts.

Are you referring to the wires that go from battery to battery?


Sent from my iPhone using Tapatalk

[Shuga]

Also I ordered a new charging port from amazon. It had the same part number but when it came yesterday I noticed the one red wire by the positive and negative terminals appeared to have a female plug, where I need a male put to, plug into the female wire that goes into the other wiring harnesses. Is this something I can modify to make it work? Because I can’t seem to find one that has male on that end.

I have two of these


This was the original


Sent from my iPhone using Tapatalk

[Shuga]

So on the 10 prong I’m not a zero voltage on the White/Yellow wire Would that mean a new ignition?


Sent from my iPhone using Tapatalk

[Shuga]

Ordered and installed new ignition, nothing. Same. No click to the solenoid


Sent from my iPhone using Tapatalk

[PingEye3]

Have you used your ohmmeter to check the continuity at each plug as KGSC said above, between: J1 Pin1 to Pin2 and also Pin1 to Pin3 to make sure direction switch is working. Do the same for J4 Pin1 to Pin2, foot switch. Finally, check J3 Red to Red/Yel then from Red/Wht to Org/Red - operation of tow switch. You can also verify wiring to KS by checking J1 Pin9 to Pin 10.