|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
08-25-2013, 02:03 PM | #1 |
Smoov az a gravy sammich
Join Date: Oct 2008
Location: Limestone, Illinois
Posts: 3,462
|
G1 again...
Ok guys, neighbor is working on a G1. It keeps flooding out and not running. good fuel pressure, good spark. Carb was cleaned and reinstalled. Unsure of what to check now. Any help is appreciated Cart runs on premix...
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
08-25-2013, 02:13 PM | #2 |
Gone Wild
Join Date: Oct 2010
Posts: 6,730
|
Re: G1 again...
Check all these...
Compression, at least 90#. Fuel mixed no heavier than 70:1. Should be at least 100:1. When you say fuel pressure, what do you mean? With the stock pulse pump, it has minimal pressure and little flow. Carb float is set correctly. Reed cage is closing properly. Any pressure coming out of the carb inlet when cranking? |
08-25-2013, 03:42 PM | #3 |
Smoov az a gravy sammich
Join Date: Oct 2008
Location: Limestone, Illinois
Posts: 3,462
|
Re: G1 again...
New B&S fuel pump. Has great flow to carb.
|
08-25-2013, 03:45 PM | #4 |
Gone Wild
Join Date: Oct 2010
Posts: 6,730
|
Re: G1 again...
Did you check any of the other things I mentioned?
|
08-25-2013, 05:56 PM | #5 |
Gone Wild
Join Date: Nov 2011
Posts: 232
|
Re: G1 again...
float set to high. needle&seat dirty.
|
08-25-2013, 09:21 PM | #6 |
Smoov az a gravy sammich
Join Date: Oct 2008
Location: Limestone, Illinois
Posts: 3,462
|
Re: G1 again...
Needle and seat are not dirty. The whole carb was just rebuilt...
|
08-26-2013, 05:57 PM | #7 |
Gone Wild
Join Date: Nov 2011
Posts: 232
|
Re: G1 again...
ya might try lowering the float level, make sure the float don't have a hole in it also.
|
08-26-2013, 06:17 PM | #8 |
Smoov az a gravy sammich
Join Date: Oct 2008
Location: Limestone, Illinois
Posts: 3,462
|
Re: G1 again...
I'll try it and see where that gets it
|
08-28-2013, 11:33 PM | #9 |
Getting Wild
Join Date: May 2013
Posts: 127
|
Re: G1 again...
Had the same problem
Take a look at the bottom of the carb where the bolt goes through the float bowl The bottom of mine was ate up and it was sucking fuel between the bottom and the bowl |