starting procedure ?

joe cool · 06-30-2018, 02:10 PM

I have a 91 ez-go two cycle gas. I just rebuilt it and it runs down the road fine. It starts very well when its warm. The problem is when its cold . I can't seem to get the correct combination of throttle and choke. How do you guys start yours? full choke ,? partial choke? When it does start it seems to smoke some ,I still have the 50 to 1 mix in it.When it starts cold it has to run about 30 seconds to smooth out and be driveable. I was thinking of richening the carb but it runs so well I hate to mess with it . By the way it still has the factory Pulsar ign.
Any ideas? thanks

cart around · 06-30-2018, 02:47 PM

The rings have most likely not seated yet. Don't change anything until you run that first tank, and switch to 128:1.

I have an 87 2pg. On the first start of the day, I pull the choke all the way. Step on the pedal, and it jumps to life. I immediately push the choke back in. Rest of the day I just step on the pedal. Mine really does not like the choke.

joe cool · 06-30-2018, 05:09 PM

Thanks I'll just run the snot out of it then

06-30-2018, 02:10 PM	#1
joe cool Not Yet Wild Join Date: Apr 2018 Posts: 21	starting procedure ? I have a 91 ez-go two cycle gas. I just rebuilt it and it runs down the road fine. It starts very well when its warm. The problem is when its cold . I can't seem to get the correct combination of throttle and choke. How do you guys start yours? full choke ,? partial choke? When it does start it seems to smoke some ,I still have the 50 to 1 mix in it.When it starts cold it has to run about 30 seconds to smooth out and be driveable. I was thinking of richening the carb but it runs so well I hate to mess with it . By the way it still has the factory Pulsar ign. Any ideas? thanks
joe cool Not Yet Wild Join Date: Apr 2018 Posts: 21

06-30-2018, 02:47 PM	#2
cart around Test before replacing Join Date: Aug 2013 Location: Ohio side of the Pennsylvania border. Posts: 3,495	Re: starting procedure ? The rings have most likely not seated yet. Don't change anything until you run that first tank, and switch to 128:1. I have an 87 2pg. On the first start of the day, I pull the choke all the way. Step on the pedal, and it jumps to life. I immediately push the choke back in. Rest of the day I just step on the pedal. Mine really does not like the choke.

06-30-2018, 05:09 PM	#3
joe cool Not Yet Wild Join Date: Apr 2018 Posts: 21	Re: starting procedure ? Thanks I'll just run the snot out of it then
joe cool Not Yet Wild Join Date: Apr 2018 Posts: 21

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Forum
Valve Adjustment procedure for '91 CC	Gas Club Car
RXV battery connection procedure	Electric EZGO
Procedure for connecting charger	Electric Club Car
1989 marathon starting procedure gas	Gas EZGO
Is there a break in procedure for 295cc	Gas EZGO

Today
BGW	Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum