|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
02-14-2020, 10:16 PM | #21 |
Gone Wild
Join Date: Jun 2019
Posts: 230
|
Re: Tube Bending
Front half of cage is close to completion. I am going to weld in a rear flip seat to the rear of the cage.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
02-15-2020, 06:40 AM | #22 |
Getting Wild
Join Date: Nov 2017
Posts: 134
|
Re: Tube Bending
Looking good!
Sent from my SM-N960U using Tapatalk |
02-23-2020, 05:51 PM | #23 |
Gone Wild
Join Date: Jun 2019
Posts: 230
|
Re: Tube Bending
Front half of the cage is officially bolted into place. Now, Time to work on the back half of the cage.
|
02-23-2020, 06:01 PM | #24 |
Getting Wild
Join Date: Nov 2017
Posts: 134
|
Re: Tube Bending
|
02-23-2020, 08:48 PM | #25 |
Searching for The Way
Join Date: Oct 2009
Location: Medina, Ohio (NEOHIO)
Posts: 11,421
|
Re: Tube Bending
|
02-24-2020, 05:31 PM | #26 |
Gone Wild
Join Date: Jun 2019
Posts: 230
|
Re: Tube Bending
Made the foot plate of rear half of cage. The goal is to build somethin like the item in the last pic. Its all going to be a one piece unit roll cage and the rear seat is going to flip down and that area is going to become a cargo bed for hauling stuff. Just have to land on final size of with of foot plate. The one pictured is 10" which I think is to small. Thinking somewhere around 12-13 inches. Anyone have any suggestions.
|
02-24-2020, 07:53 PM | #27 |
Gone Wild
Join Date: Jun 2019
Posts: 230
|
Re: Tube Bending
This little tubing jig is the only way to go. Especially when cutting on angles.
|
03-02-2020, 07:37 PM | #28 |
Gone Wild
Join Date: Jun 2019
Posts: 230
|
Re: Tube Bending
a little more work today.
|
03-16-2020, 09:38 PM | #29 |
Gone Wild
Join Date: Jun 2019
Posts: 230
|
Re: Tube Bending
playing around today
|
03-16-2020, 09:57 PM | #30 |
Runs with scissors-
Join Date: Dec 2010
Location: Da UP
Posts: 1,962
|
Re: Tube Bending
Nice work!
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
Roll-Cage & Tube Bending Ideas | Design Center | |||
Bending pipe | Lifted Golf Carts | |||
Bending Top Struts | Gas Yamaha | |||
tube bending software | Design Center | |||
Conduit bending | Design Center |