|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
09-23-2020, 06:11 AM | #1 |
Gone Wild
Join Date: Oct 2010
Location: Central New York
Posts: 812
|
G - 9 clutch bolt question
Im putting a G9 yamaha clutch on a clone motor. I cut the shaft and threaded it to the 3/8ths 24 as the stock engine had. Problem I have is I dont have the stock bolt but I have a few of the right bolts. Does the head of the stock bolt cover only the inner clutch shaft or should it be wide enough to cover the outer clutch shaft too? Smaller washer to just cover the shaft or bigger to catch both?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
09-23-2020, 01:04 PM | #2 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: G - 9 clutch bolt question
Must catch both, or the outer portion will come flying off at high speed while driving.
|
09-23-2020, 06:08 PM | #3 |
Gone Wild
Join Date: Oct 2010
Location: Central New York
Posts: 812
|
Re: G - 9 clutch bolt question
Thanks again this site is the best!!!
|
|
|
Similar Threads | ||||
Thread | Forum | |||
2 U bolt or not 2 u bolt, That is the question | Electric Club Car | |||
how do i get the clutch bolt out | Gas Yamaha | |||
Starter Bolt Broke Use other bolt question | Electric EZGO | |||
clutch bolt | Gas Club Car | |||
96 DS stock drive clutch bolt size (exterior bolt) | Gas Club Car |