|
|
|||||||
| Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
  |
|
|
Thread Tools | Display Modes |
03-19-2016, 06:47 PM
|
#1 |
|
Gone Wild
 Join Date: Apr 2014
Location: Ohio
Posts: 960
|
QUESTION on G8 driven clutch
new to the Yamaha.. I picked up a g8 recently with a ton of issues...I finally got the engine to run and I noticed on the driven clutch between the sheaves there was a spacer/washer floating between them, is there suppose to be a spacer there or maybe it might of broke loose from one of the sheaves.
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
03-19-2016, 08:21 PM
|
#2 |
|
Vegas modded 420
Join Date: Jun 2009
Location: West MI
Posts: 15,443
|
Re: QUESTION on G8 driven clutch
Most yamaha secondaries have a nylon washer between the secondary sheaves. Its mostly so they don't touch when closed or make noise touching. I took mine out but it didn't really matter. Then again it wont touch until your belt gets worn a lot and mine never does (or if you remove the belt). Later I put a cut sheave on and that did change things it has a lower gear on take off.
Sheaves are all metal except the rubber seal on the bronze bushing in the center of the movable sheave and the plastic pads on the spring perch that run against the ramps. |
|
|
|
|
03-19-2016, 10:32 PM
|
#3 |
|
Gone Wild
Join Date: Apr 2014
Location: Ohio
Posts: 960
|
Re: QUESTION on G8 driven clutch
Thanks sho305 for the reply and info.
|
|
|
|
|
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Driven clutch question | Gas EZGO | |||
| driven clutch question | Gas EZGO | |||
| Driven Clutch Question | Gas Club Car | |||
| CC Driven clutch question | Gas Club Car | |||
| driven clutch question | Gas EZGO | |||
Linear Mode
