|
|
|||||||
| Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
  |
|
|
Thread Tools | Display Modes |
09-06-2014, 09:55 PM
|
#21 | |
|
Gone Wild
Join Date: Oct 2010
Posts: 6,730
|
Re: G14 wont fire
Quote:
The small black wire on the starter ground should be feeding a fuse that feeds the ground for the backup buzzer, the CDI, the regulator, and the starter solenoid. |
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
09-06-2014, 10:04 PM
|
#22 | |
|
G8 Specialist
Join Date: Jun 2009
Location: Phoenix
Posts: 7,799
|
Re: G14 wont fire
Quote:
Bet it goes to the igniter!! G16 on, don't have that wire, cause they have a different ignition. Man Don, your smart!!    |
|
|
|
|
|
09-06-2014, 10:06 PM
|
#23 |
|
Not Yet Wild
Join Date: May 2012
Posts: 34
|
Re: G14 wont fire
Doing some more searching here I see more people with the same symptoms and its the ground wire. I'm going to check that in the morning, hope thats the culprit.
|
|
|
|
|
09-06-2014, 10:09 PM
|
#24 | |
|
Gone Wild
Join Date: Oct 2010
Posts: 6,730
|
Re: G14 wont fire
Quote:
|
|
|
|
|
|
09-07-2014, 11:23 AM
|
#25 |
|
Not Yet Wild
Join Date: May 2012
Posts: 34
|
Re: G14 wont fire
Well, if its the wire that connects to the ground lug on the starter generator, that is conneted and grounded fine. It goes up to a fuse that is mounted right next to the back up alarm. What are the wires going under the motor? Im thinking a oil pressure switch. Looks like a ton of unessesary wiring for a simple press the pedal and go motor.
|
|
|
|
|
09-07-2014, 12:04 PM
|
#26 |
|
G8 Specialist
Join Date: Jun 2009
Location: Phoenix
Posts: 7,799
|
Re: G14 wont fire
That is low oil sensor
Then I wonder if you have igniter issues |
|
|
|
|
09-07-2014, 02:20 PM
|
#27 |
|
Not Yet Wild
Join Date: May 2012
Posts: 34
|
Re: G14 wont fire
Took the whole body off of it today so I could see better. If I just hold the pedal to where it would just crank I will sit and run at low idle. I can roll the throttle very slowly and it will run rough. If I roll it to full throttle it will cut right off. Im thinking coil, wish I had one laying around to try.
|
|
|
|
|
09-09-2014, 11:01 PM
|
#28 |
|
G8 Specialist
Join Date: Jun 2009
Location: Phoenix
Posts: 7,799
|
Re: G14 wont fire
Ya know, just thinking about this, if you or anybody else added lights, a radio or any other accessory to your car, and didn't ground back to the battery, that could be causing this!!
|
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| 92CC wont fire | Gas Club Car | |||
| Turf 1 wont fire | Gas Club Car | |||
| 84 gasser wont fire | Gas EZGO | |||
| G9 Wont Fire Up | Gas Yamaha | |||
| Engine wont fire | Gas EZGO | |||
Linear Mode
