2006 ezgo txt stock harness....what are these wires?

[nick731]

hey mates, I just picked up a 2006 ezgo txt cart. it has a front light bar and integrated rear lights. the key ignition has off-on-lights. but no lights are working and following the harness from the front light i found these wires that arent connected to anything. anyone know what they are?

front driver side


driver side battery compartment


driver side fuse connection (i have never seen this setup before)


the cart also has a radio system (two front two rear) that is missing the head unit and i will be tracking all that down as well but was hoping that the light system may be oem and familiar to some of you guys. any help would be great! thanks! Nick

[JohnnieB]

Here's a schematic for a stock accessory wiring harness.
There are some extra wires that are hooked up depending on whether or not there was turn signals installed.

Hope this helps.

[nick731]

k ill try and figure it out. hopefully i can figure out that schematic! is there a schematic that does not have the horn/volt meter/ turn signal switch/ turn lights ? thanks, nick

[scottyb]

Is it a series or pds cart?

[nick731]

series.

[simple man]

That fuse panel is the same one I have on my industrial cart. On mine all that is 12V! It may not be on yours! I'd check it with a DMM to make sure. I also had problems with corrosion on mine. Pull the fuses and clean both them and the panel. Mine was also mounted where mud and water could get on it! I cleaned it all up and moved it out of the splash area.

[razor1]

I believe the black and yellow are for your horn, which will then correspond to wires in the front that should connect to your horn switch.

The red and brown in the front usually belong together on a cart that does not have turn signals.

Your best bet is to use a wiring diagram and follow the voltage, but start at your fuse panel, because corrosion there could kill the whole circuit.

Good luck.

[LostHusker]

One set is for the horn button on the floor, the second set go to the brake pedal if a brake light kit is installed. Most of these type wiring kits either are added aftermarket or it come this way on freedom model carts.

[nick731]

thanks guys! when you say one set are you referring to the front pairs for the brakes and the yellow brown pair is the horn? i will start at the fuse panel and report back

[nick731]

Originally Posted by razor1

I believe the black and yellow are for your horn, which will then correspond to wires in the front that should connect to your horn switch.

The red and brown in the front usually belong together on a cart that does not have turn signals.

Your best bet is to use a wiring diagram and follow the voltage, but start at your fuse panel, because corrosion there could kill the whole circuit.

Good luck.

do you mean that i need to connect the brown wire to the red?