|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
08-19-2011, 08:18 PM | #1 |
Not Yet Wild
Join Date: Aug 2011
Posts: 4
|
basket case older gas ez-go
this week i got a older gas ez-go from the boneyard.(for free). it has a robin 244cc motor (it says 2pg on it) i have looked at some of the threads and can't find my answers so here it goes
1. the off/on switch has two wires that go nowhere(where do both wires go) 2. there is no throttle switch,just a cable to the carb.(what tells the starter to engage) 3. how does the governer work? (might sound stupid but i am new to golf carts) |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
08-20-2011, 06:54 AM | #2 |
Gone Wild
Join Date: Aug 2011
Location: West Central Illinois USA
Posts: 294
|
Re: basket case older gas ez-go
Alright a free be. Hate to say it. But you might be better off parting it out and using the $$ to buy a cart in one piece.
Mark |
08-20-2011, 02:31 PM | #3 |
Not Yet Wild
Join Date: Aug 2011
Posts: 4
|
Re: basket case older gas ez-go
ttt please help
|
08-20-2011, 03:22 PM | #4 |
Hammer Down !!!!
Join Date: Jun 2010
Location: Lake Geneva, WI
Posts: 2,681
|
Re: basket case older gas ez-go
Here's a basic wiring diagram for the Marathon 2PG to start with - this should help you get your ignition switch hooked up right.
Now, as to the lack of an accel switch, it's mounted on the drivers side firewall where the hard linkage from the pedal attaches to the throttle cable (not at the pedal as one would assume) so it very well may be there, it's just a standard roller microswitch - let me know if you need a pic to help locate it and I'll try and gety one for you. The governor is simple on these, it's an arm located on the drivers side just in front of the driven clutch (the arm ends right at the center of the clutch cover) - as the clutch expands, it eventually contacts the governor arm which pulls the governor cable that is attached to your carb, throttling you back a little to keep the RPM's down |
08-20-2011, 10:04 PM | #5 |
Not Yet Wild
Join Date: Aug 2011
Posts: 4
|
Re: basket case older gas ez-go
thanks brew for the help on understanding how the governor works its pretty simple once you figure it out. As for the throttle, the cable mounts to the pedal under the floorboard and a rod that comes though the middle of the firewall with a big half round washer. with no switches at ether spot,any more help or pics would be great thanks
|
08-21-2011, 11:21 AM | #6 |
Not Yet Wild
Join Date: Aug 2011
Posts: 4
|
Re: basket case older gas ez-go
ttt
|
|
|
Similar Threads | ||||
Thread | Forum | |||
cut-in front basket/brushgaurd | Design Center | |||
The Bucket/Basket Case is Alive!! | Gas Yamaha | |||
24 hp honda no fire got cart as basket case any help | Big Block Talk! | |||
Looking for a EZ GO side basket | Golf Carts and Parts | |||
the basket case lives | Electric Yamaha |