|
|
|||||||
| Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
|
|
01-29-2017, 07:55 PM
|
#1 |
|
Gone Wild
Join Date: Feb 2015
Location: Myrtle Beach S.C
Posts: 151
|
Ez go charging
Have an 07 ez go pds. 36 volt New Crown battiers power wise 2 charger. Model 28115 g09. Will run at 10 amps for about an hour the clicks off. Any suggestions?
Sent from my SM-G925T using Tapatalk |
|
|
|
01-29-2017, 08:02 PM
|
#2 |
|
Gone Wild
Join Date: Feb 2015
Location: Myrtle Beach S.C
Posts: 151
|
Reed switch is bypassed
Sent from my SM-G925T using Tapatalk |
|
|
|
|
01-29-2017, 09:56 PM
|
#3 |
|
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Ez go charging
What's the voltage at the end of that hour at 10a? While the charger is still running. Reed switch should have nothing to do with this.
|
|
|
|
|
01-29-2017, 10:58 PM
|
#4 |
|
Gone Wild
Join Date: Feb 2015
Location: Myrtle Beach S.C
Posts: 151
|
15 min unplugged 37.2. - 1 hour later off charger 36.9. - 3 hours later off charger 36.9. I think the battiers are holding charge.
Sent from my SM-G925T using Tapatalk |
|
|
|
|
01-30-2017, 07:56 AM
|
#5 |
|
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Ez go charging
I need numbers while the charger is running, not after...
|
|
|
|
|
01-30-2017, 11:43 AM
|
#6 |
|
Gone Wild
Join Date: Feb 2015
Location: Myrtle Beach S.C
Posts: 151
|
43.8
Sent from my SM-G925T using Tapatalk |
|
|
|
|
01-30-2017, 12:39 PM
|
#7 | |
|
Techno-Nerd
 Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: Ez go charging
Quote:
However they work the same, just different electronics. Your new batteries are not being fully charged. After they have off the charger for 12 hours, they ought to read at least 38.2V and at 3 hours they should be reading higher than that. (Voltage vs SoC chart attached) |
|
|
|
|
|
01-30-2017, 12:44 PM
|
#8 |
|
Gone Wild
Join Date: Feb 2015
Location: Myrtle Beach S.C
Posts: 151
|
They were at 35.9. I charged for an hour till the charger cut out. Those number are with only an hour of charge.
Sent from my SM-G925T using Tapatalk |
|
|
|
|
01-30-2017, 12:49 PM
|
#9 |
|
Gone Wild
Join Date: Dec 2009
Location: Aiken, SC
Posts: 13,120
|
Re: Ez go charging
If you can borrow a charger from someone see if it behaves the same way. I'm thinking the logic board is going bad but another charger would help confirm that.
|
|
|
|
|
01-30-2017, 12:56 PM
|
#10 |
|
Gone Wild
Join Date: Feb 2015
Location: Myrtle Beach S.C
Posts: 151
|
That's what I'm going to do today.
Sent from my SM-G925T using Tapatalk |
|
|
|
|
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Charging | Gas EZGO | |||
| Charging | Electric EZGO | |||
| 2006 TXT 20+amps but not charging, hot charging cable | Electric EZGO | |||
| Battery Charging Question (How to keep from over-charging) | Electric EZGO | |||
| ? on charging my TXT | Electric EZGO | |||
Hybrid Mode