2007 ezgo st gas upgrades

[dulla311@cox.net]

I'm looking for upgrades ie suspension, body kit for a 2007 ezgo st gas and there isn't any listed for this model. What comparable cart can I get that will be interchangeable for my model?

[kgsc]

Similar to a short body workhorse based on a txt frame. Should already have a 4” lift. How many bolts hold the steering column to the floor? 3 is the old style and 4 is newer.

[dulla311@cox.net]

I'll have to look at the bolts when I get home. It is lifted but I was looking at an independent suspension kit and a madjax body kit.

[kgsc]

The ST350 came in a short wheelbase and a long. The pic of mine is a long.

[Cartmaster]

The TXT kits may fit the short body haulers, but I doubt will fit an ST unless a short based sport model which I think is on a TXT frame. The fronts will fit both frame sizes. The lift kits for Txt should fit most ST models unless the axle is already below the springs. A specific rear kit would likely be needed in this case unless you are adept at DIY fabrication.
Don't quote me on this, but I am sure kgsc will confirm either way.

[dulla311@cox.net]

Mine is the short wheel base

[Cartmaster]

So if based on the TXT frame the body kits should be fine. You don't say which model you have so a picture would help.

[kgsc]

Rear axle is already under the springs and if I remember correctly the perches are part of the axle. Most lift kits have lift perches so they won’t work here. Lift blocks would though. Front suspension is txt based but could be old or new style. On the short body the regular txt based bodies will work. To double check look where the bed pivots and see if those joints are part of the frame or on 2 uprights coming up from the floor. If the latter, txt frame.

Like this
https://www.countrycat.com/arctic-ca...232%7c%7eU-2/y

[dulla311@cox.net]

https://photos.app.goo.gl/J1NAYBDH6tNomVkr9

[Cartmaster]

Exactly the reasons for my comments regarding the axle and frame type. If you have the box hinges on the frame, it's the only difference between ST and TXT and if not using the box, can be cut off. If you have a change of plan, they can be welded back in place. I believe the sport models are just built on a standard TXT frame.

EDIT
Just seen the picture. Any TXT body kit should fit. Need to see the way the axle bolts to the springs to confirm lift kit options. Maybe a picture under the rear would help if you can. Only other thing is confirming steering. Will take another look to see if I can figure it out.

Ok, you will need pre 2001.5 lift kit for the front!