|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
06-14-2014, 11:51 AM | #1 |
Not Yet Wild
Join Date: Dec 2008
Location: Normangee,Tx
Posts: 47
|
pds slow after new controller,sol. ect.
working on friends 02 EZGO PDS, brought cart in not running, controller was smoked. been sitting in barn a couple years, no rat damage visible. replaced batteries, new controller 350 amp Curtis, new solenoid, new resistor. everything clean looks good now. o.k. here's the problem, the cart starts to move forward normally , then after about 20 ft. it slows to a crawl. I have not added diode to small solenoid post yet. any suggestions appreciated.
Last edited by geno1066; 06-14-2014 at 12:04 PM.. Reason: wrong title |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
06-14-2014, 02:27 PM | #2 |
Gone Wild
Join Date: Sep 2012
Location: Savannah, GA
Posts: 2,760
|
Re: pds slow after new controller,sol. ect.
Does the new curtis 350 use the speed sensor input from the motor? Is the wiring from speed sensor in good shape?
|
06-14-2014, 05:11 PM | #3 |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: pds slow after new controller,sol. ect.
Put it into diagnostic mode and it might give you an error code.
Text at bottom of attached label tells you how to get into diagnostic mode and lists error codes. |
06-14-2014, 09:04 PM | #4 |
Not Yet Wild
Join Date: Dec 2008
Location: Normangee,Tx
Posts: 47
|
Re: pds slow after new controller,sol. ect.
getting 4 beeps ,says high throttle sensor, start again Monday, thanks for all info.
|
06-14-2014, 09:06 PM | #5 |
Not Yet Wild
Join Date: Dec 2008
Location: Normangee,Tx
Posts: 47
|
Re: pds slow after new controller,sol. ect.
JohnnyB,sounds like you are on top of it.
|
06-14-2014, 09:07 PM | #6 |
Not Yet Wild
Join Date: Dec 2008
Location: Normangee,Tx
Posts: 47
|
Re: pds slow after new controller,sol. ect.
Sportscoupe, sounds like you are on the right trail., thanks
|
06-14-2014, 09:09 PM | #7 |
Not Yet Wild
Join Date: Dec 2008
Location: Normangee,Tx
Posts: 47
|
Re: pds slow after new controller,sol. ect.
JohnnyB I think u have one BA cart.
|
06-15-2014, 06:39 AM | #8 |
Gone Wild
Join Date: Sep 2012
Location: Savannah, GA
Posts: 2,760
|
Re: pds slow after new controller,sol. ect.
|
06-15-2014, 08:32 AM | #9 | |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: pds slow after new controller,sol. ect.
Quote:
Mode. The error codes will occur after the initial set of beeps and will consist of two sets of beeps. Since the cart takes off normally and then goes into a reduced performance mode, the error code won't be heard until the performance is reduced. The most likely suspects are: Speed Sensor: Beep - Pause - Beep-Beep-Beep (1-3) Low Voltage: Beep-Beep - Pause - Beep (2-1) Welded Contacts: Beep-Beep-Beep - Pause - Beep-Beep (3-2) |
|
06-15-2014, 10:34 AM | #10 |
Not Yet Wild
Join Date: Dec 2008
Location: Normangee,Tx
Posts: 47
|
Re: pds slow after new controller,sol. ect.
We will jump on it tomorrow, I have always gained a lot knowledge on carts from you guys, I always admire other people that want to help someone. thanks a lot from EasyGO Gene.
|