|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
12-31-2016, 04:39 PM | #1 |
Gone Wild
Join Date: Sep 2008
Location: Eastern NC
Posts: 432
|
Powerdrive 3 ,model 26580 charger
I have a model 26580 lester 48 volt charger,that the amp meter flutters from 14/15 to 9 amps,back and forth .mulimeter shows it is charging...owner says it get hot,,any help?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
01-01-2017, 10:35 AM | #2 |
Gone Wild
Join Date: May 2015
Location: Central Florida
Posts: 2,114
|
Re: Powerdrive 3 ,model 26580 charger
Diode board is most common issue
|
01-01-2017, 06:01 PM | #3 |
Gone Wild
Join Date: Sep 2008
Location: Eastern NC
Posts: 432
|
Re: Powerdrive 3 ,model 26580 charger
Checked both diode boards,they checked o/k,tried on another cart,still flutters
|
01-01-2017, 07:42 PM | #4 |
Gone Wild
Join Date: May 2015
Location: Central Florida
Posts: 2,114
|
Re: Powerdrive 3 ,model 26580 charger
and how did you check them?
|
01-01-2017, 07:55 PM | #5 |
Gone Wild
Join Date: Sep 2008
Location: Eastern NC
Posts: 432
|
Re: Powerdrive 3 ,model 26580 charger
With ohmmeter,I disconnected wires to each diode,checked with ohmmeter,one way low resistance,reversed test leads and other way high resistance,
One diode plate was positive,other was negative |
01-01-2017, 08:33 PM | #6 |
Gone Wild
Join Date: Sep 2008
Location: Eastern NC
Posts: 432
|
Re: Powerdrive 3 ,model 26580 charger
Is that the correct way to check?
|
01-02-2017, 08:37 AM | #7 |
Gone Wild
Join Date: May 2015
Location: Central Florida
Posts: 2,114
|
Re: Powerdrive 3 ,model 26580 charger
Lets do the easy way.
Put the meter on continuity and check the diode, meter beeps, diode no good |
01-02-2017, 09:15 AM | #8 |
Gone Wild
Join Date: Feb 2015
Location: Quad cities
Posts: 334
|
Re: Powerdrive 3 ,model 26580 charger
To check diode you need to remove it from circuit put your meter on ohms or diode check take leads on diode check it then swap the leads and check it again if diode is good it will read one way and not the other way with leads.If diode reads both ways its junk if it wont read at all its junk.The easy to remove from circuit is to unbolt it from the plate.Check the connections on the amp meter they use a isolator to keep it from grounding out i have seen them come loose the amp meter has to have a good connection as it sends power to the battery also check all connections inside of charger.
|
01-02-2017, 08:19 PM | #9 |
revolutiongolfcars.com
Join Date: Mar 2010
Location: Golf Car Capital of The World... Augusta, Georgia
Posts: 10,224
|
Re: Powerdrive 3 ,model 26580 charger
It's probably just a weak meter. A diode that is slightly out of range can cause the meter to bounce but 90% of the time, it's just a weak stepper motor in the meter. The charger is supposed to get hot. Take a look at the attached photo.
|
01-03-2017, 02:23 PM | #10 |
Gone Wild
Join Date: Sep 2008
Location: Eastern NC
Posts: 432
|
Re: Powerdrive 3 ,model 26580 charger
Checked diodes again,good one way only,checked connections all good,should I reset obc?
|
|
|
Similar Threads | ||||
Thread | Forum | |||
club car powerdrive battery charger model 17930 | Electric Club Car | |||
looking for a Powerdrive 3 26580 wiring diagram | Electric Club Car | |||
Powerdrive model 1870 gone bad | Electric Club Car | |||
PowerDrive vs. PowerDrive 2 Charger? | Electric Club Car | |||
PowerDrive Charger 48 Volt Model 17935 | Electric Club Car |