|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
12-03-2015, 10:51 AM | #1 |
Not Yet Wild
Join Date: Nov 2015
Posts: 8
|
EH29C pre MCI valve replacement
Ok I'm getting closer to finding my problem with this motor but still need help diagnosing and repair direction. I have a ezego eh29c pre MCI that has about 65 pounds of compression. It runs but is very hard to start and backfires occasionally. I have taken motor out and have the head off. I noticed a small oil leak where the head meets the block. There is a lot of built up dusty crusty dirt only in that location. Looking at the head gasket it doesn't appear to be blown through. Would it be and I just can't see it? Should I take it down further and replace rings? Bore over? Machine head? Cylinder bores look to be ok. I'm looking for some guidance. Upon looking at head and pulling valves I see that the seats are pitted and leaking by. Can I replace valves and lap new ones back in or is there a valve seat grinder available? Find a new head? which seem to be very pricey. What do I do?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
1989 EZGO - Reed Valve Replacement? | Gas EZGO | |||
briggs vtwin valve oil seal which valve | Big Block Talk! | |||
cc reed valve replacement | Gas Club Car | |||
Valve Key/Collet Replacement | Gas EZGO | |||
EZGO EH29C replacement motor | Gas EZGO |