|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
12-12-2015, 09:02 PM | #1 |
Not Yet Wild
Join Date: Nov 2015
Posts: 13
|
Another "won't turn over" topic
I have the 295cc EZGO engine i just replaced piston rings head gasket carb gaskets and exhaust gaskets. I thought the engine needed to be bored until I looked at the cylinders they looked like new so just went with new Rings because the others were worn and expanded. Reassembled the engine and still won't turn over. Both plugs sparking as good as can be when I shoot a little starter fluid in the carb it halfway hits but then goes back to just turning without running. Need help. I'm on the way to get a compression gauge before I tore it apart I had 60 lb. in one cylinder and 30 in the other. I believe I need at least 90? That's what I was told by a guy at a local shop
Sent from my iPhone using Tapatalk |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
12-12-2015, 09:20 PM | #2 |
Gone Wild
Join Date: Apr 2015
Posts: 256
|
Re: Another "won't turn over" topic
Pull the fuel line from the carb and make sure you have fuel coming out when you crank it.
The pump can loose prime and or garbage in the tank can plug up the filter ect. Or the fuel pump could have lost a diaphragm. Did it sit for more then 4 months while it was rebuild? If so the carb may be gummed up. Pull the bowl and clean it. |
12-12-2015, 09:53 PM | #3 |
Not Yet Wild
Join Date: Nov 2015
Posts: 13
|
No it was bone stock nothing was ever changed for about 6 months then I put all the new gaskets and piston rings in. And I have taken the carb apart and cleaned it it's getting fuel
Sent from my iPhone using Tapatalk |
12-12-2015, 10:27 PM | #4 |
Gone Wild
Join Date: Apr 2015
Posts: 256
|
Re: Another "won't turn over" topic
Double check your valve settings and cam timing?
|
12-13-2015, 11:42 AM | #5 |
Not Yet Wild
Join Date: Nov 2015
Posts: 13
|
Everything is good now but now it's shooting oil out of te breather I started another topic with a video. Need help figuring that one out
Sent from my iPhone using Tapatalk |
12-13-2015, 11:48 AM | #6 |
Not Yet Wild
Join Date: Nov 2015
Posts: 13
|
It's a pain to get down in there so figured I'd ask before taking it all apart again
Sent from my iPhone using Tapatalk |
12-14-2015, 05:55 AM | #7 |
Gone Wild
Join Date: May 2009
Posts: 377
|
Re: Another "won't turn over" topic
What's the compression now?
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
will 2011 "PH" controller work on 2007 "PQ"? | Electric Club Car | |||
Club Car belt/clutch won't "change", as stuck in "low" gear | Gas Club Car | |||
Why "Carbon Fiber" "Wood grain" and Diamond Plated? | Gas EZGO | |||
Turn Signal "bleed over"? | Gas Yamaha | |||
Need Help! "Ultimate Buggies" Turn signal kit install on a factory lit TXT | Gas EZGO |