|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
03-31-2008, 08:20 AM | #1 |
Getting Wild
Join Date: Mar 2008
Posts: 145
|
Upgrading for Speed II
For fear of totally hijacking jtbird23's thread.
What I learned in his thread. 1. I can go with a two speed motor and have the option to switch from torque to speed. 2. I can rewire and go to 48V and use the same motor. What remains is correctly identifying my cart. Although Ive been reading a bunch Im still in the dark about a few things. What I have is a 2000 EZ 36v. It has the f/r controller below the seat. I do not see a tow/run switch under the seat. It says TXT by the key. From what I've gathered it is a series cart. NON PDS/DCS correct? Does this make it a controller cart or a resistor cart? I also don't see is how it would be much cheaper to go the 48v system since the price of new batteries alone is more than what EMP is quoting on the 2 speed motor and switch kit. Add the new wires and soleniod and it's a hefty upgrade. Plus I'd be left with a set of relatively good 6 volt batteries. My thought was this: Upgrade the to the 2 speed motor and switch now. ($325). Then, when New battery time comes upgrade to the 8 volts and new wiring, soleniod. Assuming that I have a resistor cart. If not, then the addition of the 48v controller probably makes this more expensive than I want get into. (for now) Additional question. Will EMP's two speed motor be as easily adaptable to 48v as mine? Im assuming it is since they will be redesigning mine. I dont know if it is a swap or I have to wait for my motor to be returned. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-31-2008, 08:22 AM | #2 |
Getting Wild
Join Date: Mar 2008
Posts: 145
|
Re: Upgrading for Speed II
BTW scottyb, learning is half the fun!
Oh, and I can add photos if it helps with identification. Thanks |
03-31-2008, 09:48 PM | #3 | |
Not Yet Wild
Join Date: Mar 2008
Posts: 5
|
Re: Upgrading for Speed II
Quote:
|
|
03-31-2008, 11:18 PM | #4 |
Gone Wild
Join Date: Jan 2008
Posts: 151
|
Re: Upgrading for Speed II
You could also get 6 eight-volts, but adding two 6volts works... But, your not supposed to mix old batteries with new ones... BAD BAD BAD things happen!!!
|
04-01-2008, 12:18 AM | #5 |
Getting Wild
Join Date: Mar 2008
Posts: 145
|
Re: Upgrading for Speed II
|
04-01-2008, 09:08 AM | #6 | |
Gone Wild
Join Date: Jan 2008
Posts: 151
|
Re: Upgrading for Speed II
Quote:
YAY MONEY (I wish I had some) |
|
04-01-2008, 09:20 AM | #7 | |
Getting Wild
Join Date: Mar 2008
Posts: 145
|
Re: Upgrading for Speed II
Quote:
Although Im still wondering how I figure out if I have a controller or resitor car. |
|
04-01-2008, 09:42 AM | #8 | |
Gone Wild
Join Date: Jan 2008
Posts: 151
|
Re: Upgrading for Speed II
Quote:
The resistors are connected to a "speed board" which has copper contacts and a arm controlled by you gas pedal... This can be upgraded with only a heavy-duty 48V solenoid... <<< Resistor Coils The controller cart doesn't have coils or a speed board, it has a little box that creates an electrical signal when you press the gas... This kind needs a whole new controller... <<< Solid State Speed Controller |
|
04-01-2008, 12:04 PM | #9 |
Getting Wild
Join Date: Mar 2008
Posts: 145
|
Re: Upgrading for Speed II
Would be my luck. Im guessing which ever I have would be found inside the large rectangular box by the batteries. The bottom bolt proved too much for the cracker jack socket set I have up here at the house.
Working 10+ hour midnight shifts leave me too gassed to go out to the shop in the mornings. (Funny, it doesnt hurt as bad when beer is involved) Will this be where I have to look? Or are under the motor cover? Or am I just too sleepy and it's somewhere else? |
04-01-2008, 05:26 PM | #10 |
Gone Wild
Join Date: Jan 2008
Posts: 151
|
Re: Upgrading for Speed II
??? I think your question has just gone over my head, ask roady89, he is the sites admin, and VERY smart about models and makes... etc...
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Upgrading Cables | Electric Yamaha | |||
Upgrading for Speed | Electric EZGO | |||
Upgrading the 1990 CC seems to never stop | Members Rides | |||
More Speed | Electric Club Car | |||
speed | Gas EZGO |