Quote:
Originally Posted by usgicollector
I only recommend using a OEM brake.
Replacing the Park Brake on an E-Z-GO RXV
Remove the two T27 torx screws on the rear cover
Choke the wheels
Disconnect the negative cable on the battery pack
Turn the ignition key to reverse, wait till the reverse indicator becomes silent then turn key off
Disconnect wire harness from motor brake
Remove the three 10mm hex screws and lock washers from brake
If bolts are rusty replace them
Remove brake if there is residue on motor be sure to clean it use a wire brush
Position the brake with the connector at the top, install the three hex screws loosely.
Connect wire harness to the motor brake, re-connect battery negative cable
Turn ignition to neutral, turn Run/Tow switch to Tow position, this provides power to the brake to align the disc material
Set torque wrench between 53 to 65 in. lbs (6-8 Nm) and tighten screws be sure not to over tighten
Turn key back to the off position
Move Run/Tow switch back to Run position
Put rear back cover on
|
Thanks! Any chance you can look at my thread I posted a bit earlier? I am having all sorts of issues....