|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
02-26-2020, 11:02 AM | #1 |
Not Yet Wild
Join Date: Feb 2020
Location: Blaine, TN
Posts: 28
|
Anyone experienced w/Curtis PMC-5A controller & PB-1 POT?
I'm attempting to get an old cart going after some wires were disconnected during a lift project and can't find info on connections between POT & controller.
The POT is a CurtisPMC PB-1 w/three wires red-white-black The controller is Curtis PMC-5A (possibly a dinosaur due to lack of info found on the net?) The controller connections going to the POT are shown below. Just not sure how they match up to the red-white-black from the POT. Control harness actually has 4 wires at the POT, the 3 that goe to the controller plus a blue wire. Any help? The second pic shows the POT wires connected to the contol harness but I'm not sure the connections are correct. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
Is the Curtis 1311-1101 Controller Handset PMC a good controller | Electric EZGO | |||
I'm new to the world of carts, I need some advice from experienced mentors | Gas EZGO | |||
Need input from experienced CC guys | Electric Club Car | |||
Just Something I have Experienced With The 36 Volt Motor Theory | Electric Club Car | |||
needing some help from the experienced ones... | Electric Club Car |