|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
10-07-2013, 03:05 PM | #1 |
Not Yet Wild
Join Date: Sep 2013
Posts: 3
|
95 EZGO TXT not wanting to go
I rode the cart for awhile then I was doing routine checks for loose wires, I checked all battery terminals and FNR switch for loose connections and when I finished I was gonna put the cart up and now it wont move. The Soleniod is engageing I checked everything I know to check I have good voltage to Micro switches and I ohm the FNR switch and micro switch they tested good. I also checked the controller and it also tested good I don't whats wrong Thanks for any help
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
10-07-2013, 03:55 PM | #2 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,406
|
Re: 95 EZGO TXT not wanting to go
Is the solenoid clicking when you try to go?
|
10-07-2013, 04:22 PM | #3 |
Not Yet Wild
Join Date: Sep 2013
Posts: 3
|
Re: 95 EZGO TXT not wanting to go
yes it is
|
10-07-2013, 04:41 PM | #4 |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: 95 EZGO TXT not wanting to go
If the solenoid is clicking, the problem is in the high-current circuit.
Jack rear wheels off ground so the half ton cart doesn't take off unexpectedly and run over someone or something. Connect your DVM between the B- and M- terminals on the controller. Press pedal just far enough for solenoid to click. You should read FULL battery pack voltage. If not, find the missing voltage. (Attached schematic has high-current circuit highlighted) If so, press pedal to floor. The voltage should decrease to Zero. If not, the controller, or throttle input to controller is bad. |
10-07-2013, 05:44 PM | #5 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,406
|
Re: 95 EZGO TXT not wanting to go
I just spoke with laser and he said he tightened up the F&R terminals before the cart stopped working. I wondering if a worn contact was drawn down into the housing by the tightening and now contact is lost...... he's gonna see if tightening the center pivot nut can reunite the F&R contacts. It's worth a shot....
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Wanting to go to 48v | Extreme DC! | |||
Wanting a ezgo | Golf Carts and Parts | |||
1993 ezgo marathon ...wanting to make faster | Electric EZGO | |||
98 EZGo Not wanting to Go | Electric EZGO | |||
wanting to buy a clutch for a 92 ezgo 4 stroke | Golf Carts and Parts |