Starts then won’t

[Scottstiles]

I have a 2002 gas club car it starts then it won’t
Got great spark plug is good
Got great foul
Checked all my wires all is tight and on.
Where should I go from here thank you

[BearsFan315]

I have a 2002 gas club car it starts then it won’t

so it will start and then wont run ??
or
it will start and run, then will NOT restart ??
...if so how long in before it will restart, or what do you have to do to get it started ??
...how long will it run, or will it run until you stop ??

[mrlmd]

You have to clarify what you are saying.
When you turn the key on and step on the gas pedal does the starter engage and the engine turn over, or does nothing happen? (Possible bad key switch or one of the micro switches).
If the engine rotates, is it going at speed, or is it really slow? (Low battery charge).
Does it rotate but not "catch" and fire, does it cough? Or there is no ignition? When it starts and runs, is it smooth and rides OK?
And the problem is intermittent?

[Scottstiles]

Sorry key on starter kicks in some time it will run then other times it won’t.
When it don’t it aks like it fires to take off then it don’t start.
Hope this helps.

[Scottstiles]

When it starts it runs good.
When it don’t the motor turns over good and I have fire going to plug but will not run.

[BearsFan315]

ok

so is this random or not starting after it has been running ? or if you stop then go to start again ? or been sitting then go out and gambling on starting or not ??

if it is after it has been running and warmed up, may be a bad component that is dying and malfunctions when it heats up.

[Scottstiles]

It does it cold or hot . Run it for a hour let it set and it won't start back up. Come in the next morning and try it some time it will start other times it won't. But key is on motor turns over and got spark.

[BearsFan315]

wonder if it could be the coil or solenoid acting up (they tend to act up when they start going bad, work intermittently or only when cool, when warm, etc..)

these are pretty simple machines granted 10x more complex then my '29 with a few wires.

article on testing a solenoid not sure applicable it is ??

Post on here with some trouble shooting tips/ tricks