Ergo RXV 2008 won’t fully charge or move

usgicollector · 08-20-2018, 05:30 AM

[quote=Cheeeco;1533052]

Quote:

Originally Posted by BobBoyce

Yes, the motor brake must be installed to pass the powerup test. Check the battery in your ohm meter, a low battery could cause erronious readings.

I would replace your throttle and brake encoders, and the motor speed encoder bearing. When I metered the voltage on all 3 of those encoders, it was reverse polarity 3.6 volts coming from the damaged 5V regulator in the Danaher controller. Those encoders likely did not survive that reverse polarity event.

Bob

Bob,
Is the part # for the motor speed encoder bearing #612595? YES
Thanks..

Sent from my iPad using Tapatalk

Cheeeco · 08-28-2018, 03:44 PM

[quote=usgicollector;1533172]

Quote:

Originally Posted by Cheeeco

Happy to report the cart is rocking and rolling. Thanks to everyone especially Bob. Thanks again.

Sent from my iPhone using Tapatalk

BobBoyce · 08-28-2018, 04:36 PM

Quote:

Originally Posted by Cheeeco

Happy to report the cart is rocking and rolling. Thanks to everyone especially Bob. Thanks again.

Similar Threads
Thread	Forum
8V batteries won't fully charge	Electric Club Car
Ergo express was towed improperly and now won't move	Electric EZGO
Ergo rxv 2008 brake solinoid question	Electric EZGO
Fully charged and will not move	Electric Club Car
Charger won`t fully Charge.	Electric Club Car

Today
BGW	Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum