|
Electric Yamaha Electric Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
02-19-2014, 11:12 PM | #1 |
Not Yet Wild
Join Date: Dec 2013
Posts: 9
|
Rear end lifted and now it is not straight.
I just installed a lift kit in my g19. First off this is a homemade lift kit.
The front fit perfect. Then I got to the rear. I installed the shock extenders and put the tires on. In stepped back and looked at the rear tires. They are crooked and off about 1 inch. The driver side rear does not rub and the passanger side barely does. I DID NOT install a Longer stabilizer plate. (Could this be it?) Any ideas what went wrong? Can some please guide me into the right direction. Thanks |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
02-19-2014, 11:21 PM | #2 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Rear end lifted and now it is not straight.
Yes thats the problem. The panhard bar needs to sit close to level when the cart is on the ground, or you will have bad "bump steer". You will need to make an extension to locate the panhard bar level. I dont recommend lenghtening the bar because of the stability issue when the bar is not kept level.
|
02-21-2014, 10:16 PM | #3 |
Not Yet Wild
Join Date: Dec 2013
Posts: 9
|
Re: Rear end lifted and now it is not straight.
Thanks so much. That is exactly what it is.
What is the best way to make one? I got a 8 inch steel bar and bolted it to it up. I also need a brace for it so that it will not move. |
02-21-2014, 10:19 PM | #4 |
I Refuse To Get Stuck!!!
Join Date: Jun 2010
Location: Hilton,NY
Posts: 5,427
|
Re: Rear end lifted and now it is not straight.
I use 3/8"x3" flat-bar for the drops in my kits(1/4" will work,I like some overkill).Just drop the bar down from the frame the same amount as your lift-height.Add atleast 1 more bolt though,since with 1 mount-bolt at the frame where the plate will be,will allow it to rock sideways.I use the original-hole(1/2"-bolt),and 2-more(3/8") above it.Works great.Hope this helps.
|
11-21-2017, 08:33 AM | #5 |
Not Yet Wild
Join Date: Nov 2017
Posts: 1
|
Re: Rear end lifted and now it is not straight.
I am having the same problem with my cart, my question is wha is the stabilizing bar? Do you a picture of it that would help me locate it?
Thank you. |
Tags |
g19, lift, rear axel |
|
|
Similar Threads | ||||
Thread | Forum | |||
4x4 golf cart with a 4.0 Straight 6 | Lifted Golf Carts | |||
G19 Bar: Bent or Straight? | Electric Yamaha | |||
Rear lifted and non-lifted springs | Electric Club Car | |||
Let me get this straight, Brother in law and I disagree | Electric EZGO | |||
Looking for a straight passenger side rear axle for 95 gas medalist | Golf Carts and Parts |