|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
08-12-2015, 08:06 PM | #1 |
Not Yet Wild
Join Date: Mar 2011
Location: Fosters al
Posts: 15
|
97 dcs controller
new controller arrived today a dcx 400.really excited about getting it installed. I had been troubleshooting to make sure my old controller was bad. One of the tests I did was to make sure the motor was good by installing jumpers and connect motor to 12 volts. Only problem is I failed to remove one of the jumpers between S1 and A1 on the motor when I connected the leads back up( how could I miss that). Well of course the controller would not work. It would run forward when the switch was in reverse but I got a code, 5 red blinks on signal light on controller. The resister on the solenoid got smoking hot. don't know whether to install another resister and try to troubleshoot or what. does any one out there have any suggestions? Hope I haven't ruined a new controller.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
|
Similar Threads | ||||
Thread | Forum | |||
WTS/WTT 400amp SepEx Controller for Series Controller | Golf Carts and Parts | |||
RXV controller not responding to upgrade handheld device to program controller | Electric EZGO | |||
Plum Quick Bandit + 500 AMP Controller OR Executioner w/ Stock Controller | Electric Club Car | |||
Trade 400 amp 36v Curtis controller for 500 amp or higher 48v controller | Golf Carts and Parts | |||
Did lift kit cause controller to die? What are controller options? 95 EZGO 25864G05 | Electric EZGO |