Reverse buzzer diconnect

[cgray11]

Does anyone know how to disconnect the reverse buzzer on an ezgo rxv?

[Maverick18]

Watching

[Rgvrxv]

I think disconnecting the reverse buzzer on the RXV will shut down the cart. The solution is to "quiet" the buzzer with foam, duct tape, etc.; thats what i did, and it worked nicely. There are numerous threads on this forum on that subject. Good luck.

[JohnnieB]

In today's litigious society, I'd think long and hard about disabling the beeper. (Read attached article)

Just quietening it down a bit may be more defensible in court.

[cgray11]

Decided to leave it alone, Thanks guys

[Volt_Ampere]

Mine was very annoying so I put a little tape over the hole. It's still loud enough to hear but not annoying. I would not recommend disconnecting it but quieting it down a little is what I did.

[kgsc]

I used duct tape and it can still be heard but not as noisy. It is under the controller cover if you wish to test options..

[cgray11]

Thanks guys

[eflyguy]

I pulled mine, very annoying at horse shows. Car doesn't beep when going backwards..
..a

[Sethjamto]

Originally Posted by Volt_Ampere

Mine was very annoying so I put a little tape over the hole. It's still loud enough to hear but not annoying. I would not recommend disconnecting it but quieting it down a little is what I did.

This is exactly what I did too. Put a little piece of foam in the buzzer hole and covered it with tape. I can still hear it, but I don't have to yell over it when talking to someone!