Club Car DS motor VERY stuck

[LukeL]

Hi everyone, I have a 2004 IQ DS that was in a flood, and the motor is done. It's a GE motor, if that matters.

I tried to remove the motor, and of course the housing came off the armature, and the armature is stuck to the spline.

I took the whole rear end out of the car, flipped the brake drum over, and dropped it repeatedly, but the old armature still remains on the spline.

What can I do from here?

Thanks,
Luke

[Swan]

have you soaked it in PB Blaster , if not I would start with that or something like it and then return to the dropping

[LukeL]

Originally Posted by Swan

have you soaked it in PB Blaster , if not I would start with that or something like it and then return to the dropping

Thanks. I'll try it.

[TahoeDawgZ71]

This will work. Make sure to either remove all of the lug studs or take an old brake drum and turn it around backwards to make sure you don't damage the studs.

You Tube

You Tube