|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
07-19-2019, 09:32 AM | #1 |
Gone Wild
Join Date: Apr 2010
Location: Stringer, MS
Posts: 200
|
Reverse Buzzer always buzzing
2003 Ezgo Pds.
Buzzer was removed and voltage gauge was installed using the buzzer wires. Grn/blk and red wire. traced to pins 5 and 10 on plug j1 on controller. any ideas? Trouble indicator is useless without buzzer. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-19-2019, 09:40 AM | #2 |
Gone Wild
Join Date: Apr 2010
Location: Stringer, MS
Posts: 200
|
Re: Reverse Buzzer always buzzing
problem solved, cockpit trouble.
|
07-19-2019, 12:51 PM | #3 |
Gone Wild
Join Date: Jun 2017
Location: Savannah, GA
Posts: 6,539
|
Re: Reverse Buzzer always buzzing
[emoji1303]
|
08-10-2019, 01:23 PM | #4 |
Not Yet Wild
Join Date: Aug 2019
Posts: 10
|
Re: Reverse Buzzer always buzzing
I had the same issue off and on before my cart died. Wondering if it's a problem with the key assembly or a problem with my controller?
|
01-11-2021, 11:23 PM | #5 |
Not Yet Wild
Join Date: Dec 2020
Posts: 5
|
Re: Reverse Buzzer always buzzing
Hi, I'm having this same problem with my TXT PDS. Reverse buzzer always on whenever run/tow is on RUN. Not a continuous tone, but beep, beep, beep...
I'm looking for code to troubleshoot cart in limp mode 80% of the time. New batteries, speed sensor with cable, magnet, solenoid. Cables tight and crimps are good. Voltage at least 36v under load. |
01-12-2021, 04:03 PM | #6 |
Not Yet Wild
Join Date: Dec 2020
Posts: 5
|
Re: Reverse Buzzer always buzzing
Hi all, could anything other than a bad controller cause the reverse buzzer to be on all the time?
I verified it's connected to pin 5 and 10 and no continuity between. I guess that would explain it being in limp mode most of the time... Thanks. |
01-12-2021, 04:38 PM | #7 |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: Reverse Buzzer always buzzing
Pin-5 is a voltage input to the controller. The beeper is also connected to the B+ by the same wire. The beeper is turn on when Pin-10 is connected to B- through the controller.
Try putting the controller in diagnostic mode and listen for a beeped error code. Text at bottom of attached PDS label tells you how to get into diagnostic mode. Also attached a schematic for a PDS. If controller is bad, replace it with an Alltrax XCT48400-PDS. |
01-13-2021, 11:14 AM | #8 |
Not Yet Wild
Join Date: Dec 2020
Posts: 5
|
Re: Reverse Buzzer always buzzing
Thanks. When entering diagnostic mode the beeping pauses for a second, beeps 4 times (Freedom plug is installed), then starts beeping continuously again.
Is that the "1-1 Controller Failure" code? The cart does move, it's just in limp mode most of the time. I did a frame up refurb on this one- paint matched to the buyers new corvette! |
01-13-2021, 11:17 AM | #9 |
Not Yet Wild
Join Date: Dec 2020
Posts: 5
|
Re: Reverse Buzzer always buzzing
|
|
|
Similar Threads | ||||
Thread | Forum | |||
wiring a reverse light to the reverse buzzer? | Gas Yamaha | |||
F/r switch help. Reverse buzzer is on in forward and not on reverse | Electric EZGO | |||
Reverse buzzer sounds even when not in reverse | Columbia ParCar | |||
E-Z-GO Solenoid buzzing in reverse | Electric EZGO | |||
Reverse buzzer ? | Electric EZGO |