|
Electric Yamaha Electric Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
06-24-2017, 06:50 AM | #1 |
Not Yet Wild
Join Date: Apr 2016
Posts: 34
|
g29 no speed
First off thanks for any help you may be able to give me.
I have a 13 G29 that is no longer going as fast as it use to. mods are as follows XCT48400YDRE controller a 500a controller 3" jakes spindle lift 20" tires 6 month old batteries The cart ran fine the last time I used it, but now it maxes out at 5mph, post controller install it would go around 20-23mph. it still has all of the low end torque that is use to but it just does not go as fast as it use to. according to the volt gauge I am fully charged. I checked to make sure all of the connections are clean and tight and that is not the issue. any help would be appreciated. ciao |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
06-24-2017, 09:58 AM | #2 |
Not Yet Wild
Join Date: Apr 2016
Posts: 34
|
Re: g29 no speed
Ok so I found my problem.
There is a small 3 wire triangle plug that was not fully seated. The wire goes from the motor to I think the controller. Since installing the lift, I guess it is now to short. My question is do they make an extension for this harness or do I have to cut the wires and extend them myself? Ciao |
06-24-2017, 11:22 AM | #3 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: g29 no speed
That's tach sensor wire. I don't know of any extension cord for it.
|
06-24-2017, 04:15 PM | #4 |
Not Yet Wild
Join Date: Apr 2016
Posts: 34
|
Re: g29 no speed
good to know. do you know what most people do to extend that wire when they lift their carts?
|
06-24-2017, 04:31 PM | #5 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: g29 no speed
You can cut & splice to make wires longer ( that's what I'd do). I suggest soldering the connections & heat shrink to seal it up.
|
06-27-2017, 06:10 AM | #6 |
Not Yet Wild
Join Date: Apr 2016
Posts: 34
|
Re: g29 no speed
Thanks man, that is what I was going to do if I couldnt find an extension.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
MCOR? Speed Sensor? Controller? Cart Runs at half speed. Advice, please. | Electric Club Car | |||
Loud noise and clicking at full speed on new high speed motor. | Electric EZGO | |||
Golf cart slowly losses speed and come to stop but in 5 mins back to full speed?? | Electric Club Car | |||
1204 controller, half-speed forward full speed reverse | Electric EZGO | |||
1985 G1 Runs fine low speed , high speed run for a mile then fall on its face | Gas Yamaha |