Controller or Motor

[808 Go ez]

What would you do if you if you had to choose between buying a New upgraded Controller or Motor. I cant get both of them right now,so deciding which one first. What controllers or motor brands is good to get. I wouldn't mind 25mph speed if that possible. I have a 2001 48v G19e cart. Thanks

[cgtech]

I would get a alltrax controller first for sure. It will get you better torque, and a speed boost to 24 mph with the stock motor. Plus it is programmable to work Correctly with many other motors (the stock one is not).

[808 Go ez]

Thanks CGtech, That is what i will do first. Should i get a new solenoid too at the same time.

[808 Go ez]

Where can i find model# on my GE controller? It has the make GE 48V-350amp and serial# SH4D0350047p but no model#

[808 Go ez]

CGtech Whats the difference between Alltrax and FSLIP controller. Which would you go with. I here the Alltrax needs some wire crimping and FSLIP is just plug and play. Do they both have the same speed and torque values.

[cgtech]

The FSIP is a factory style replacement, and still uses the tach sensor, you may get no speed increase at all. The one wire modification needed for a Alltrax in a g19 is very easy. I believe the FSIP is not exactally plug-n-play, i think you have to take apart the plug on your cart wire harness and swap wire 11 & 17.

[808 Go ez]

Thanks CGtech,really appreciate it. Alltrax has a controller for my sepex system?

[cgtech]

Yes, A DCX400G19 is a easy swap. And comes with the adapter board to plug into the factory wire harness.

[808 Go ez]

Thanks again CGtech.

[808 Go ez]

CGTech,Got my Alltrax controller and solenoid on the way. I might need some help with install. Happy Happy Happy.
So far i got new Batteries,upgrade to 4gauge wires for the batteries.Do i need to 4gauge the wires to the motor and controller too? Thanks