97 ezgo will not move

[tpace1972]

have a 97 somebody put a bad wire on the f & r switch and burnt it I replaced the end and contacts in switch then I found the saft switch was bad I by passed it now relay clicks when I press pedal so I went to charge battery but charger fuse was blown and board looked bad where orange wire goes so I jumped the two black wires where it would charge they was over 40 volts when I tried again in r you hear the motor making a sound but wheels do not move and voltage drops some in f the relay clicks but no motor sound voltage barley moves I was checking voltage at relay I have it both side even when pedal was not pressed I didn't know if it was back feeding somewhere. On my f & R switch there are four cables two on rt post one on top and one on left but there is not one on the bottom does that sound right. what should I check next

[scottyb]

Dude. Can you break that down into paragraphs or sentences ? I tried reading it twice but I keep running out of breath...

[tpace1972]

Ok to start when I press pedal the relay clicks but the wheels dont move seem to have good voltage what should I check next

[LostHusker]

We need to identify your cart first, is it a DCS or Series Cart?

[tpace1972]

I forget which is which mine has the r&f switch lever by your knee

[scottyb]

That is either series or DCS (?), does the back side of the F&R look like a silver hockey puck? Is there a toggle switch on the controller cover?
PS the relay is a Solenoid.

[tpace1972]

The controler cover has nothing on it cart serial is 996521 under that you have A2397 the f&r switch looks somthing like that with four copper contacts

[scottyb]

Sounds like a series cart.You need to fix the F&R cable locations and who knows what else? there is only one cable per F&R lug connection. Here is a diagram to check all the heavy cable locations.

[tpace1972]

Thanks. What about terminal c it shows one to motor and one to the controller. Right now mine has two on terminal B and nothing on A so I will trace them and put them where they belong. Thanks again I'll let you know what happens

[tpace1972]

I was looking at your site the F&R cam you sell here http://www.cartsunlimited.net/Batter..._Upgrades.html is what they had burnt up and I replaced I'll check the wires again thanks