|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
12-18-2012, 12:08 AM | #1 |
Gone Wild
Join Date: May 2011
Location: Oklahoma City
Posts: 204
|
Trouble getting into forward
97 TXT 4 stroke robin eng
Have trouble getting into forward. Once in forward it stays, until you switch to reverse. it shifts into reverse just fine. Adjusted shift linkage and it's moving shaft in rear end all the way as far as it will get, Sounds/feels like it is not catching the gear. It trys to move a little and I hear a click in the rear and the eng revs up, when the rpm comes down I hear a repeated click. Sometimes pushing the car foward and starting the eng it will catch and go. If someone will point me in the right direction to the repair manuel for rear ends I would Thank You. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
12-18-2012, 05:31 AM | #2 |
Gone Wild
Join Date: Sep 2012
Location: Michigan
Posts: 351
|
Re: Trouble getting into forward
check shifting cable first, sounds like the cable is not putting the trans all the way into forward, adjust cable so it goes into forward more
|
12-18-2012, 08:25 AM | #3 |
Getting Wild
Join Date: Aug 2012
Location: minnesota
Posts: 103
|
Re: Trouble getting into forward
I just did the ones on my 95 it wouldn't go into forward either. I found the reverse cable had been crushed so it wasn't moving freely into forward. I ended up pulling both and only replacing one. I think it was like $25.
|
12-18-2012, 11:14 AM | #4 |
Gone Wild
Join Date: May 2011
Location: Oklahoma City
Posts: 204
|
Re: Trouble getting into forward
The cable is moving the shaft on the rearend all the way. The problem apears to be inside the rear end. I would like the ezgo repair manuel for the rearend.
|
12-18-2012, 07:53 PM | #5 |
Gone Wild
Join Date: Sep 2012
Location: Michigan
Posts: 351
|
Re: Trouble getting into forward
Take the rear hubs off before you go any further, the hubs have splines where they slide on the axle shafts and the spline inside the hub strips out all the time on these carts, remove that big nut in the center of the rear hub and the hub should slide off, look at those hubs first.
|
12-18-2012, 08:43 PM | #6 |
Gone Wild
Join Date: May 2011
Location: Oklahoma City
Posts: 204
|
Re: Trouble getting into forward
I'll check that out
|
12-22-2012, 06:26 PM | #7 |
Gone Wild
Join Date: Sep 2012
Location: Michigan
Posts: 351
|
Re: Trouble getting into forward
update??
|
12-24-2012, 12:35 PM | #8 |
Gone Wild
Join Date: May 2011
Location: Oklahoma City
Posts: 204
|
Re: Trouble getting into forward
Been buzy getting ready for the end of the year and have not had time to work on golf cars. The weather here in Oklahoma for the next week is COLD. I'll post results when I get the hubs off and try to post pics after I get them out.
One side is reverse and the other foward... Which side if foward? Driver?? |
12-25-2012, 07:14 AM | #9 |
Gone Wild
Join Date: Sep 2012
Location: Michigan
Posts: 351
|
Re: Trouble getting into forward
BOTH forward, BOTH reverse, differential in rear axle just like a car
|
01-04-2013, 11:59 PM | #10 |
Gone Wild
Join Date: May 2011
Location: Oklahoma City
Posts: 204
|
Re: Trouble getting into forward
Turned out to be the shaft that goes inside was sticking, a little wd-40 on the shaft and it would turn just a little more and enough to go into and out of foward
|
|
|
Similar Threads | ||||
Thread | Forum | |||
96DCS Goes Forward in both reverse and Forward | Electric EZGO | |||
2006 ezgo forward is reverse and reverse is forward please help | Electric EZGO | |||
Reverse alarm sounds in Forward, wont go forward or reverse | Electric Club Car | |||
Alarm sounding in forward. No movement in forward or reverse | Electric Club Car | |||
Forward Reverse switch melted on forward...have question about replacement part | Electric Club Car |