95 controller over voltage
I have a 95 ezgo medalist that spent a couple days under water about a month ago. We have dried everything out as best we can. It has one year old batteries from another non flooded cart, voltage of the pack is 38.2. Ran ok for a while then it would start slowly going down after about ten minutes. Ran down quickly, in about two minutes it wouldn't move. After letting sit for a couple hours it would run fine for less time and get down to nothing quicker. We are now to the point it will only run slowly. I went through the ez go diagnostics thread and everything checked out ok until I get to the controller section. I am getting voltages between B+ and M- of 134 to 142 at full throttle. This jumps between these numbers and doesn't stay steady. Only thing I can think is there is water in controller but I'm not sure it is worth a new one with the value of the cart being what it is. Especially having been underwater. This is a non dcs cart. Are there any other explanations other than the controller for having too high of a voltage?
|