|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
04-13-2017, 07:37 PM | #1 |
Not Yet Wild
Join Date: May 2012
Posts: 2
|
How to wire 2 motors in a resistor card
I have 2 marathon carts that are essentially identical. I want to chop them up and make a dual rear axle/dual motor cart. I have no idea how to wire this. Will I need to run dual resistors? 36 or 72 volt battery pack?
Any information or suggestions would be greatly appreciated. Thanks |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
04-13-2017, 07:52 PM | #2 |
Gone Wild
Join Date: Mar 2015
Location: Central mn
Posts: 1,036
|
Re: How to wire 2 motors in a resistor card
Welcome to the forum.
I hope you post pictures of this build. It should be interesting/cool! |
04-13-2017, 07:57 PM | #3 |
Not Yet Wild
Join Date: May 2012
Posts: 2
|
Re: How to wire 2 motors in a resistor card
When the chassis is complete I'm going to make a dump box for it with an electric trailer jack to tip it.
|
04-13-2017, 08:36 PM | #4 |
Gone Wild
Join Date: Nov 2016
Location: Wilmington NC USA
Posts: 268
|
Re: How to wire 2 motors in a resistor card
To do it efficiently you should use electronic speed controls
You may be able to to use 1 large control that can handle the load of both motors. I'm not sure but im sure someone else on here can help you. You probably want 48v or even more, you’re going to need a heavy-duty forward reverse switch probably some big relays that can handle around 350amps each motor. Sounds like a cool idea, I cant wait to see some pictures of the progress. |
04-13-2017, 08:45 PM | #5 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: How to wire 2 motors in a resistor card
If you must use resistor control, you will have to use a separate resistor control for for each motor. Each resistor control is only good enough for one motor. You will burn out the coils & contacts quickly if you rig one set of stock coils to 2 motors. You could rig up a linkage to operate both from one pedal.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
2 Motors and Misc Parts for 1984 EZGO Resistor Cart | Golf Carts and Parts | |||
are these motors compatible pic inside how to wire | Electric EZGO | |||
resistor wire | Gas Club Car | |||
5TH speed resistor has a burned mark on resistor board and melted the wire | Electric EZGO | |||
Complete Wire Kit for 91' 36V 5 resistor | Electric Club Car |