Limp Mode

[WejaZ28]

That did it! Connected red and white wire and runs like new.

Thanks so much for working me through this. This is a great site.

Can you give me a recommendation for controller, solenoid and wires.

Thanks again JohnnieB

[JohnnieB]

Need to replace the Run/Tow switch, but it'll be okay to run it with the wires relocated until the replacement switch arrives.

------------------

Alltrax XCT48400-PDS (or larger) user programmable controller.
MZJ400, or SW180, or SW200 solenoid.
All ten high amp cable 4Ga or thicker. (Unless damaged, the original F1 & F2 cables are sufficient)

I got most of my stuff from Cart Unlimited: https://www.cartsunlimited.net/alltrax-xct-sepex--.html

[WejaZ28]

Thanks again....