|
|
|||||||
| Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
  |
|
|
Thread Tools | Display Modes |
01-31-2011, 07:59 AM
|
#21 |
|
G8 Club Founding Member
Join Date: Sep 2010
Location: Middle of Virginia, USA
Posts: 4,265
|
Re: G1 not running right
You can always put a fan on the front to keep just about any engine cool!
 |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
01-31-2011, 09:48 AM
|
#22 |
|
Gone Wild
Join Date: Mar 2009
Location: Raleigh NC & Bracey VA
Posts: 156
|
Re: G1 not running right
Check carb. there is a small needle valve in the top of the carb. Take it out and clean. It looks like it is just a plug, but there is a very fine hole in the bottom. Use 1 wire from a wire wheel on a grinder. soak in carb clean. This is an air jet that senses air pressure. Most common cause of having to run a partial choke to keep an engine running. found on Yamaha, Club car, and EZ-go carbs. They all have them and will cause this problem.
|
|
|
|
|
02-01-2011, 12:57 PM
|
#23 |
|
Not Yet Wild
Join Date: Jul 2010
Location: MA
Posts: 38
|
Re: G1 not running right
Alright thanks i will do that next time I get out there. I dealing with snow right now :/
|
|
|
|
|
02-02-2011, 09:13 AM
|
#24 |
|
Gone Wild
Join Date: Mar 2009
Location: Raleigh NC & Bracey VA
Posts: 156
|
Re: G1 not running right
Here in Raleigh, NC we just got rain today. Hope you do not hammered to hard with ICE
|
|
|
|
|
02-02-2011, 10:04 AM
|
#25 |
|
Vegas modded 420
 Join Date: Jun 2009
Location: West MI
Posts: 15,443
|
Re: G1 not running right
I plowed about a foot of snow out of my drive, roads not passable here if they didn't plow unless you have a 4x4. Main roads are ok but mostly white. There was one trail down the road here had to go slow in the truck. There where 3'+ drifts around buildings. That was about 8am.
|
|
|
|
|
02-09-2011, 01:53 PM
|
#26 |
|
Not Yet Wild
Join Date: Jul 2010
Location: MA
Posts: 38
|
Re: G1 not running right
Yeah its a freaking mess im running out of places to put the snow
|
|
|
|
|
02-09-2011, 01:54 PM
|
#27 |
|
Not Yet Wild
Join Date: Jul 2010
Location: MA
Posts: 38
|
Re: G1 not running right
So I moved back to the idea of rebuilding the engine in the cart... can anyone point me to a good thread on rebuilding and replacing the seals?
|
|
|
|
|
02-09-2011, 01:58 PM
|
#28 |
|
Vegas modded 420
Join Date: Jun 2009
Location: West MI
Posts: 15,443
|
Re: G1 not running right
I'm sure they are here, there is one for the seals. Then you flush the bottom end and if its ok slap a piston and the jug on it. Or get yours bored and buy the right size piston/rings. They run the best with a bore job for sure. Unless you have a '82 G1 they are different.
|
|
|
|
|
02-15-2011, 10:37 PM
|
#29 |
|
Not Yet Wild
Join Date: Jul 2010
Location: MA
Posts: 38
|
Re: G1 not running right
Once it gets warmer out I will pull the engine and take it apart to see how the internals are, if there ok I will replace the seals and hope she runs right.
PS. how do I figure out what year the cart is? |
|
|
|
|
02-16-2011, 07:14 AM
|
#30 |
|
Gone Wild
Join Date: Dec 2009
Location: Ohio
Posts: 1,143
|
Re: G1 not running right
Go to gas yamaha stickies section..
|
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| G1 not running to well | Gas Yamaha | |||
| G1 running hot | Gas Yamaha | |||
| Am I running enough oil? | Gas EZGO | |||
| 88 cc not running | Electric Club Car | |||
Linear Mode
