Took out the stupid alarm and now I'm **#kered

[ohwhofarted]

So I bought new batteries, cleaned out the rust in the tray, used ospho, painted said tray, and reinstalled the batteries. In the midst of all that, I decided to take out the stupid BU alarm that I bought years ago. Now, I have two wired without homes... and of course,like an idiot, When I was taking out the alarm, I was just cutting and pulling and not bothering taking notes.

If you look at the diagram attached, I need an answer for ?#1 and ?#2. My thoughts are I can remove ?#2 and !#1 and put ?#1 in it's place on the solenoid.

Help? I've looked through the stickys and can't figure it out.

[JohnnieB]

Yes, that should return it to the stock wiring configuration.

Here is a schematic of a series drive cart with the solenoid activation circuit highlighted.
The wire in question is the red one between Pin-4 and the solenoid coil that is not highlighted.