G29 - Alltrax Throttle Curves

[xcntrk]

Originally Posted by Volt_Ampere

Keep your eye on your motor temps. I cooked mine with that same setup. I also have a 2012 YDRE.

That's not good.
Did you have amp and RPM limits set?

[Volt_Ampere]

Yes. I had amps set at 400. At the time I had RPM set a bit high at 5000. The stock motor overheated big time.

[scottyb]

Originally Posted by Volt_Ampere

Keep your eye on your motor temps. I cooked mine with that same setup. I also have a 2012 YDRE.

I had heard about 500a being too much for the stock motor, I hadn't heard of anybody cooking the Hitachi motor at 400 amps. Were you doing alot of downhill runs, using a lot of regen? What did Alltrax have to say about your experience?

[Volt_Ampere]

No I wasn't doing any downhill runs. Just level ground. Replaced the motor with D&D and that motor is running fine - not overheating at all.

[cre73]

I also am very concerned regarding the motor lugs. Was very concerned tightening them as they moved and twisted while was doing it.

[k_aimone]

Originally Posted by Scotty07

How much is that set up? I have a 2012 stock yamaha and I've just started with upgrades. I put my back seats on this weekend. lift will be done in a couple of weeks

I am to curious about the price. I checked a local shop the stock "Torque?", it would have been $1400.

[xcntrk]

Contact ScottyB of Carts Unlimited for price and availability information. Scotty assembles a nice turn-key kit consisting of controller, solenoid, wires, and voltage meter. You can source these items elsewhere as well...