92' Marathon Elect throttle linkage

[EZGOmywallet]

I am missing something somewhere. The rod going under the brake pedal and to the very last bracket (under driver to the very far outside) is missing something to hold the rod in the bracket. I don't see anything on the end of the rod that would hold it in place.

The plastic bushing is still in the bracket hole. Does anyone know where I can find a pic/diagram of the throttle linkage, or has someone taken enough of them apart/out to know what should hold it in ? It stays in there by itself most of the time, but does "pop out" some times. When this happens, you have to lift the pedal UP with your foot(even though it is still spring loaded) to disengage the accelerator, but other then that still works. I need to fix this before my 10yr old daughter starts driving it. Thanks for any help.

[DOOmsman]

http://products.jacobsen.com/img/manuals/28789-g01.pdf

I think this will link to the page d3 it could be wear or the cam has shifted RU or Scot am I wrong here.

[EZGOmywallet]

I don't know if it is the link or a mistake, but I have a 1992 antique dinosaur. I tried to find it on there and can't. Thanks DOOmsman.

[DOOmsman]

The parts look much the same but we can wait for the elec experts.

[EZGOmywallet]

I went back and looked again, your right it does look the same. When I push the rod over like in the second pic it feels like it puts it in a bind, but the pedal still operates fine. I can't see that any of the rods/brackets are bent. It appears from the manual everything is there though........well correction, I just went and looked at the pic again and the cart....#42 "set screws" are not in mine, just empty treaded holes. I got more light under it and can see the rod move inside the screw holes as I move it out where it needs to be. The two set screws hold the rod in position. Cool, thanks for your time and trouble sir....

[DOOmsman]