|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
08-13-2009, 01:35 PM | #1 |
Gone Wild
Join Date: Aug 2009
Location: Eldon Missouri
Posts: 977
|
Stupid question ( I think )
Today, I was pulling all the old bits of belt from the drive clutch and noticed some lateral play at the pulley which can also be felt at the fan on the other side of the crankshaft I don't think that this should be happening should it ?
I figure that new bearings and seals will be required so I may as well fit new rings while i'm at it. Funny thing is, the engine is smooth and quiet and shows 116 psi compression. Would anyone know of a supplier who can provide just the necessary parts as opposed to the whole top end rebuild kits ? I checked the site sponsors but all had kits only. I don't think that I need a new piston, barrel etc. Chris. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
08-13-2009, 01:53 PM | #2 |
Gone Wild
Join Date: Feb 2009
Location: P-COLA
Posts: 1,176
|
Re: Stupid question ( I think )
Chris, some end play is normal, also necessary for proper clearance. If it runs fine, I would leave it alone.
|
08-13-2009, 01:55 PM | #3 |
****tard supreme
Join Date: Jun 2008
Location: waldo,wisconsin
Posts: 5,401
|
Re: Stupid question ( I think )
|
08-13-2009, 02:03 PM | #4 |
****tard supreme
Join Date: Jun 2008
Location: waldo,wisconsin
Posts: 5,401
|
Re: Stupid question ( I think )
i would think about installing the rings.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Stupid Question 'bout G9 | Gas Yamaha | |||
Yet another "Newby " stupid question | Lifted Golf Carts | |||
Stupid question | Electric Club Car | |||
stupid solenoid question | Electric EZGO |