|
|
|||||||
| Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
04-26-2013, 06:37 PM
|
#1 |
|
Gone Wild
Join Date: Jul 2012
Location: Climax,NC
Posts: 268
|
Solenoid stays pulled in
Like it says up top. But the cart runs and drives with a green light on the alltrax.
Turn the switch off and it goes off. Checked microswitch and it opens and closes with the pedel. Theres a diode think it could be bad? The solenoid gets hot to the touch just sitting still. Any ideas? |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
04-27-2013, 09:13 AM
|
#2 |
|
Happy Carting
 Join Date: Dec 2007
Location: Southern California
Posts: 73,417
|
Re: Solenoid stays pulled in
Sounds like a stuck closed micro switch (ms). Check the F&R ms and then the peddle box ms.
|
|
|
|
04-27-2013, 11:24 AM
|
#3 |
|
Gone Wild
Join Date: Jul 2012
Location: Climax,NC
Posts: 268
|
Re: Solenoid stays pulled in
Its a pds carts btw.
Does a pds cart have a forwars reverse ms? I also checked the microswitch under the floormat and it seems ok. I dont think its a bad solenoid would it? I can cut the key switch off and it will open. |
|
|
|
|
04-27-2013, 06:39 PM
|
#4 |
|
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: Solenoid stays pulled in
PDS cart with a DCX or a NCX, so about the only things that will keep the solenoid energized is a bad pedal switch or a bad controller.
Since the solenoid de-energizes when the key is shut off, I'm leaning towards the pedal switch being bad or the wiring to/from it being shorted together. Flip the Run/Tow to Tow and unplug J4 (cable from pedal box) from the PDS to DCX adapter and measure between Pins 1 & 2 with an Ohmmeter. Should be open with pedal up and closed with pedal down. |
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| I pulled a dummy | Big Block Talk! | |||
| Solenoid clicks and stays engaged when i cut on key | Electric EZGO | |||
| I have to keep the choke pulled out to run | Gas Yamaha | |||
| G1 Only runs with choke pulled | Gas Yamaha | |||
| Choke cable pulled out | Gas EZGO | |||
Linear Mode
