|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
07-28-2015, 08:33 AM | #1 |
Not Yet Wild
Join Date: Jul 2013
Posts: 19
|
3a Racing Industrial Touch Switch
Has anyone tried these touch switches? I bought one because I thought it would be a good look on my custom dash to turn my digital volt meter on and off. Problem is I can't figure out how to wire it. It has a three prongs. One to power it, one for the load and one for the ground.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-28-2015, 08:38 AM | #2 |
Master of All Things
Join Date: May 2013
Location: West Columbia, Texas
Posts: 17,995
|
Re: 3a Racing Industrial Touch Switch
One spade is the Pos + coming in (POWER)
One spade is LOAD (The + of what you are powering, + for your DVM, you will still need to tie the ground (-) for the DVM back to the pack which you can do by just going back to the ground to the switch) One spade is GRD- (grounded back to your pack) |
07-28-2015, 08:54 AM | #3 |
Not Yet Wild
Join Date: Jul 2013
Posts: 19
|
Re: 3a Racing Industrial Touch Switch
Awesome. Thats the direction I was heading but just wanted to make sure. Thank you.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Starter hot to touch | Gas Club Car | |||
Touch Up Finish | Electric Club Car | |||
can I get a touch more speed | Gas Yamaha | |||
touch up paint | Gas EZGO |