|
|
|||||||
| Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
03-24-2018, 04:40 PM
|
#1 |
|
Not Yet Wild
Join Date: Aug 2017
Location: Central Florida
Posts: 37
|
Ezgo diagnostics 3 beeps/2beeps
Getting a diagnostic 3/2 beeps from cart replaced solenoid with new one still getting same code....any ideas what else it could be
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
03-24-2018, 05:08 PM
|
#2 |
|
Gone Wild
 Join Date: Mar 2014
Location: NE Indiana & SW Florida
Posts: 3,238
|
Re: Ezgo diagnostics 3 beeps/2beeps help
??? This is a PDS cart right.
|
|
|
|
03-24-2018, 06:00 PM
|
#3 |
|
Not Yet Wild
Join Date: Aug 2017
Location: Central Florida
Posts: 37
|
Re: Ezgo diagnostics 3 beeps/2beeps help
Yes Pds ....did change solenoid and still get the bad solenoid beeps
|
|
|
|
|
03-24-2018, 06:17 PM
|
#4 |
|
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: Ezgo diagnostics 3 beeps/2beeps help
The first suggested corrective action on the PDS label (attached) is Check auxiliary power, the second is Replace solenoid.
 Aux power starts at the battery pack's main positive terminal, through the 10ga white wire to the positive radsok in the charge receptacle, through the reed switch to J1 Pin-4 on controller. Through PC board traces inside controller to J3 Pin-2. through one of the two sets of contacts in the Run/Tow switch, back into the controller on J3 Pin-1, through PC board in the controller and out J1 Pin-9 to one side of the solenoid coil on the yellow wire. The voltage at J1 Pins 4, 5 and 9 should be the same as the battery pack voltage |
|
|
|
|
03-25-2018, 08:45 PM
|
#5 |
|
Not Yet Wild
Join Date: Aug 2017
Location: Central Florida
Posts: 37
|
Re: Ezgo diagnostics 3 beeps/2beeps
Thanks JB....had a bad run/tow switch and when I put in one I had DPDT.....had one spade on the wrong one and it was giving an open to the controller...learned something about the diagnostics..thanks again
|
|
|
|
|
03-26-2018, 09:30 AM
|
#6 |
|
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: Ezgo diagnostics 3 beeps/2beeps
Glad to hear you found it and fixed it, thanks for the feedback.
 |
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| ezgo pds beeps and beeps | Electric EZGO | |||
| '98 ezgo Diagnostics Question | Electric EZGO | |||
| Need ezgo diagnostics for resistor wiring | Electric EZGO | |||
| Ezgo diagnostics | Test Post | |||
| Ezgo diagnostics | Electric EZGO | |||
Linear Mode
