EZGO 775 truck and 875P

[chopperspares]

I picked up 2 EZGO airport trucks. One is a 775 and the other is and 875P. The 775 is in much better shape than the 875. I pulled a Curtis PMC-5A speed controller from the 875 with the hopes of puttting it in the 775. The 775 has the old toaster elements on it. The motor that was on the 775 is GE 5BC48JB719. I'd like to put the curtis and this motor back in the 775.
I looked for data sheets on the Curtis with no success. I'm just wondering if this motor/ESC combo is compatiable. I suppose I need to match the pedal off the 875 with the Curtis ?? Are these components worth restoring or should I just go the toaster element route?

Giving it to pop for grocery store runs.

Tks

[scottyb]

I'm not familiar with those models but if they are similar then you could do this...
The donor cart needs to have the same Series drive system like the resistor coil one does.
You need to use the donor carts throttle input system.

[chopperspares]

Thanks Scotty,
We got them from a military auction. I haven't seen any on the site so far ( here ). Should I go ahead and try to get the current resistor cart wired back to operation? Or gut that harness and upgrade to that ESC that I have listed up top? It appears that those resisitor parts are cheap and fairly reliable. I wasn't able to find the model curtis on their website that I have, nor could I fing a wiring schematic. I have one for the resistor system.
Tks