Best way to acess Controller/2008 CC Precedent

[Hecky50]

How do you access the controller on a 2008 CC IQ 48v. /w 6x8. I want to see what is there so I can upgrade to a 350/400 Curtis.
Or is a Alltrax a better choice?
Terrain here is flat and smooth/ 2 person cart, may add rear seat later.

Thanks in advance.

[mymonstertruck]

Remove the two center batteries, and you will see a T-40 screw right above the tow/run switch on the aluminum cover. Remove the screw and the controller will be mounted to that plate on the back side. You should have a 250amp stock controller, so I would recommend 400 Or even a 500 amp controller. You would more than likely not see a significant increase with a 350 amp controller.

[jjance]

I would take out the two middle batteries, find the one torx screw on top of the controller compartment, remove, lift and fold down. Don't forget all the safety stuff. take pictures, run/tow to tow, disconnect battery cables + and - and interconnect cables and tape and as a safety backup draw a picture of all wiring disconnected.

You can also get at it from the rear access door but it is a tight fit.