Rear bushing removal or replacement for club car ds

[broschb]

I'm replacing the bearing in my rear axle of my 1984 club car ds. I have bearings but have not been able to find a replacement bushing.

If I can buy a new bushing I will just grind the old one off, if I can't find one i'm looking for tips on how to remove the bushing.

Does anyone know where I can buy a bushing?

Or how can I get this off? I have tried a bearing puller that I have, so far it isn't budging.

Pictures showing the size of the bearing.

Here is the album with pictures showing inches/mm


PXL_20220924_201857429.MP.jpg

PXL_20220924_202401892.MP.jpg

PXL_20220924_202440371.MP.jpg

PXL_20220924_202553197.MP.jpg

[Fairtax4me]

Take it to a shop with a press. The bushing slides off as you pull the bearing off.

[broschb]

Good idea, i'll have to find a place on Monday.

I pulled the other axle to have ready to take in somewhere. When I pulled I noticed a spring on the end of the axle between the bearing. The drive side did not have this, is it needed?

If so any ideas where to get one? The manual makes me think it should be there.

Part #4 in the image attached.

Screen Shot 2022-09-24 at 11.21.49 PM.jpg

Screen Shot 2022-09-24 at 11.20.38 PM.jpg

[broschb]

My local mechanic was able to get off the bushing and bearing with a lot of heat. I'm rolling again.