|
Electric Yamaha Electric Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
02-11-2018, 03:54 PM | #21 |
Not Yet Wild
Join Date: Sep 2017
Posts: 30
|
Re: G29 Drive troubleshooting
Got the motor out, lots of pieces fell out with it. Does this still look like a good candidate for a local rebuild place or should I send it off to one of the golf cart specific places. I was looking online, the plum quick bandit at $225 doesn't seem like a bad deal, any thoughts?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
02-11-2018, 04:13 PM | #22 |
Gone Wild
Join Date: Oct 2017
Location: Harrisburg, PA
Posts: 380
|
Re: G29 Drive troubleshooting
****, that is smoked. Personally I would go for the $225 motor. I am not sure how much a rebuild would cost but it could certainly be done if all the steel parts are intact (they would replace the copper wire).
Sent from my iPhone using Tapatalk |
02-11-2018, 04:27 PM | #23 |
Not Yet Wild
Join Date: Sep 2017
Posts: 30
|
Re: G29 Drive troubleshooting
Also if anyone reading this has a stock motor laying around they want to get rid of I am definitely interested in that option.
|
02-11-2018, 07:17 PM | #24 |
Gone Wild
Join Date: Dec 2016
Posts: 167
|
Re: G29 Drive troubleshooting
I have a stock 2007 motor. Ran fine. Just put in a D&D. I'd sell it for a $100 plus shipping. In in Michigan. 49696.
|
02-11-2018, 07:19 PM | #25 |
Gone Wild
Join Date: Dec 2016
Posts: 167
|
Re: G29 Drive troubleshooting
|
02-11-2018, 08:27 PM | #26 |
Not Yet Wild
Join Date: Sep 2017
Posts: 30
|
Re: G29 Drive troubleshooting
|
02-12-2018, 02:05 AM | #27 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: G29 Drive troubleshooting
Get rid of the stock motor, don't waste time with it!
|
02-17-2018, 02:50 PM | #28 |
Not Yet Wild
Join Date: Sep 2017
Posts: 30
|
Re: G29 Drive troubleshooting
Well i got the new(used) motor from freckles installed and still no go. I jumper tested the motor and it is good so that is not the problem.
When my original motor went out could something else have happened at the same time, could it have burned up the controller too? Any suggestions on what to check next are appreciated, this is aggravating. |
02-17-2018, 04:26 PM | #29 |
Gone Wild
Join Date: Oct 2017
Location: Harrisburg, PA
Posts: 380
|
Re: G29 Drive troubleshooting
Yes it could have damaged the controller. You can use the FSIP troubleshooting list as a start
Sent from my iPhone using Tapatalk |
02-19-2018, 09:27 PM | #30 |
Gone Wild
Join Date: May 2012
Location: Rio Verde, Az
Posts: 7,171
|
Re: G29 Drive troubleshooting
Motor failure often takes out the controller.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
need electrical troubleshooting tips on 2011 drive | Electric Yamaha | |||
92 DS Troubleshooting | Electric Club Car | |||
DCX 400 troubleshooting help | Electric EZGO | |||
Troubleshooting power drive 2 charger | Electric Club Car | |||
Troubleshooting | Electric EZGO |