|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
12-18-2009, 09:27 AM | #1 |
Not Yet Wild
Join Date: Nov 2009
Location: South GA
Posts: 24
|
01 Workhorse throttle linkage
I've just put my motor back in after a total re-build, it runs great,but at slow speed it wants to start/stop the engine. I would like to adjust it out so I can poke around the yard without the engine shutting off and on.Do you do this at the rear end or with the linkages going to the carb?I noticed the linkages have threaded ends on them and probably got twisted some during the build.Thanks
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
12-21-2009, 06:09 PM | #2 |
Gone Wild
Join Date: Nov 2008
Location: Montgomery, AL
Posts: 1,463
|
Re: 01 Workhorse throttle linkage
you can adjust both. i would start with teh rear b/c if you go too much you will loose all low end pedal. I have been known to adj teh throttl linkage a pretty good bit to get better torque, just dont go too much or the carb wont close and you can/will flood the eng
|
12-21-2009, 06:17 PM | #3 |
Not Yet Wild
Join Date: Nov 2009
Location: South GA
Posts: 24
|
Re: 01 Workhorse throttle linkage
Thanks I think I have it like I want it now. I have my lowspeed and it's running good. The carb wasn't closing and I thought it was running rich, but it was the linkage adjustment at the rearend.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Throttle linkage ball end? | Gas Club Car | |||
Sled Throttle Linkage | Big Block Talk! | |||
Throttle Linkage | Big Block Talk! | |||
Don't do this Ezgo 295/350 throttle linkage | Gas EZGO | |||
Club Car Throttle Linkage | Electric Club Car |