|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
04-17-2011, 08:43 PM | #1 |
Not Yet Wild
Join Date: May 2010
Location: Michigan
Posts: 36
|
Need help w/g16 please
I have a 01 g16 i did the thing w/the governor drilled out and put new throttle cable on it so here is the problem it seems it only has full throttle i mean u barley touch the gas and its going and if u floor it i doesnt make a difference so i put a spring on the return and still didnt help so if anyone has any suggestions i would appreciate it thanks keith. O and it did the same thing before i put the new cable on.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
04-18-2011, 06:46 AM | #2 |
maintaining a low profile
Join Date: Oct 2009
Location: SW Virginia USA
Posts: 6,314
|
Re: Need help w/g16 please
Is the butterfly in the carb opening and closing?
|
04-18-2011, 02:11 PM | #3 |
Not Yet Wild
Join Date: May 2010
Location: Michigan
Posts: 36
|
Re: Need help w/g16 please
It was when i checked it when i installed the new trottle cable.
|
04-18-2011, 03:20 PM | #4 |
Vegas modded 420
Join Date: Jun 2009
Location: West MI
Posts: 15,443
|
Re: Need help w/g16 please
Make sure it starts and idles with the pedal before it gets any throttle. Make sure it only gets full throttle with pedal all the way so its not binding something. Note the last near 1/3 of throttle on carb does very little for you only seems to work at top rpm...on a stock engine. If you still use the governor arm, that is where another return spring should be that also holds the arm down so it can't come off...if you drilled the shaft holes out.
|
04-18-2011, 06:26 PM | #5 |
LIFE IS TAKING FOREVER
Join Date: Apr 2010
Location: DANSVILLE NY
Posts: 5,327
|
Re: Need help w/g16 please
the problem we had was the stop on the carb got stuck past the stop and it was stuck wide open. this happened after we by passed the govenor. i thought something was wrong so i hooked the govenor back up and it still ran wide open. it wasent until i took the carb off i dicovered the problem. i hope this makes sence.
|
04-18-2011, 07:38 PM | #6 |
Vegas modded 420
Join Date: Jun 2009
Location: West MI
Posts: 15,443
|
Re: Need help w/g16 please
I know what you mean, I bet someone bent that tab long ago so it didn't catch....iirc the tab stops it. I used to have golfers stick pencils in there on G1s and bend them.
|
04-22-2011, 10:33 PM | #7 |
Not Yet Wild
Join Date: May 2010
Location: Michigan
Posts: 36
|
Re: Need help w/g16 please
Im going to find time this weekend to do some investigating on my nightmare thanks guys.
|