02-24-2013, 08:47 PM | #1 |
Not Yet Wild
Join Date: Feb 2013
Posts: 13
|
club car gasket
I have a mid 70's 36 volt club car,and I removed the motor to do some repairs and cleaning. My question is there was a gasket between the motor and the gear box where it mounted, does anyone know what that gasket is called, and do I need to have one there? thanks
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
02-25-2013, 08:18 AM | #2 |
Medicare Recipient
Join Date: Jun 2011
Location: West Michigan
Posts: 3,541
|
Re: club car gasket
. . . picture of it? . . .
|
02-25-2013, 09:52 PM | #3 |
Not Yet Wild
Join Date: Feb 2013
Posts: 13
|
Re: club car gasket
Here is a picture of the motor and trans axle.
|
02-25-2013, 10:48 PM | #4 |
Gone Wild
Join Date: Jun 2009
Location: Binghamton, NY
Posts: 384
|
Re: club car gasket
I do not think that there is a gasket required. Both of those parts are machined surfaces. Nothing liquid is in between that could escape. The bearing is lubed with grease, and you should lube the spline with some anti-seize compound. Otherwise, I think that you are OK!
EDIT>>> take a look at this link. Although it is not your year of cart, it is an early design and may give you some help. look at Drive Unit 1 and Drive Unit 2. http://www.golfcartpartsdirect.com/ecom-catshow/11.html |
02-26-2013, 06:05 AM | #5 |
Medicare Recipient
Join Date: Jun 2011
Location: West Michigan
Posts: 3,541
|
Re: club car gasket
. . . as easy as it is to fabricate a gasket, you could buy "thin" gasket material from Auto Zone or someplace and make one. That way you mind will be at ease. Buy a piece large enough to cover the face of the transaxle, then use a small ball peen hammer (while holding the gasket material in place) to "trace" the profile of the transaxle's inner diameter and outer diameter . . the ball peen will cut the gasket material as you "gently" tap the gasket material following the inner/outer edge of the transaxle . . . then use the ball peen to locate/cut the bolt holes too . . viola . . you made a gasket . . . I have made gaskets this way for 30 years . . .
|
02-26-2013, 02:11 PM | #6 |
Not Yet Wild
Join Date: Feb 2013
Posts: 13
|
Re: club car gasket
Thanks for the replies and the gasket idea, that I will do. My next question is what type and weight oil goes in the gear box, and how to tell if there is enough? Did I mentioned the cart has been sitting for at least 3 years without being touched, maybe longer.All the brake parts were rusted together,and full of rust instead of brake fluid.I have gotten the parts moving after a few cans of pb blaster,wd-40.wire brush and sand paper.I will post some pics later,once again guys THANKS.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
head gasket? | Gas Harley Davidson | |||
Gasket help | Gas Harley Davidson | |||
Differential gasket in g9 | Gas Yamaha | |||
Head gasket | Gas EZGO | |||
g1 exh. gasket | Gas Yamaha |