|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
04-15-2015, 07:41 PM | #1 |
Getting Wild
Join Date: Feb 2014
Location: Huntsville, AL
Posts: 141
|
Help with throttle/governor
The throttle cable in my g2 broke and when it did a spring fell off and I can't figure out how/where it goes back on. Does anyone have a picture of how it is supposed to go or maybe can tell me how it goes? uploadfromtaptalk1429144863379.jpg
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
04-16-2015, 06:27 PM | #2 |
maintaining a low profile
Join Date: Oct 2009
Location: SW Virginia USA
Posts: 6,313
|
Re: Help with throttle/governor
|
04-17-2015, 09:44 PM | #3 |
Getting Wild
Join Date: Feb 2014
Location: Huntsville, AL
Posts: 141
|
Exactly what I was looking for! Thanks a million.
|
04-17-2015, 09:45 PM | #4 |
Getting Wild
Join Date: Feb 2014
Location: Huntsville, AL
Posts: 141
|
How hard is it to remove the rear fenders of the cart?
|
04-18-2015, 06:03 AM | #5 |
maintaining a low profile
Join Date: Oct 2009
Location: SW Virginia USA
Posts: 6,313
|
Re: Help with throttle/governor
It's not too hard. Remove the seat, hinges, choke knob and shift lever, and unfasten the seat backs from the frame. There's a fastener on each side of the body and a couple in the bagwell.
Sorry, this is for a G16. Not sure about the G2, but it shouldn't be too hard. The guys in the G9 Club will be able to help. |
04-18-2015, 11:02 AM | #6 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Help with throttle/governor
Super easy to remove rear body. Flip seat up, on the ledge where rear of seat rests, there will be 3 phillip screws or 10mm bolts. Under the mat in the golfbag area find 2 more screws. If tail lights are present, disconnect them. Dont remove seats or anything else, just lift body off.
|
04-18-2015, 01:28 PM | #7 | |
Vegas modded 420
Join Date: Jun 2009
Location: West MI
Posts: 15,433
|
Re: Help with throttle/governor
Quote:
|
|
04-19-2015, 08:49 AM | #8 |
Getting Wild
Join Date: Feb 2014
Location: Huntsville, AL
Posts: 141
|
Thanks for the help. I was able to get the back off with no problem. I did find there are a few bolts missing that holds the back on, I guess from vibration. It made it so much easier to get to the rear end and the governor assembly.
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
91 Marathon Throttle/governor questions | Gas EZGO | |||
Duromax throttle setup with governor intact?? | Clone Engine Swaps | |||
Governor mod / Throttle response | Gas Yamaha | |||
WTB throttle and governor plate | Golf Carts and Parts | |||
throttle and governor cables | Gas EZGO |