|
|
|||||||
| Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
10-22-2012, 02:38 PM
|
#1 |
|
Not Yet Wild
Join Date: Oct 2012
Posts: 17
|
Speed control
2006 Ezgo 36 VDC, all of a sudden the golf cart reduced speed to about 2 to 3 miles an hour. the gas padal had no response. It will go forward and reverse but very slowly. I have removed the peal box to check it out..
How do I trouble shoot the pedal speed mechanism (electrically ) to see if is bad. I have a 3.25M ohms reading on the terminals. Does it require power? If so how much? |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
10-22-2012, 02:47 PM
|
#2 |
|
Happy Carting
 Join Date: Dec 2007
Location: Southern California
Posts: 73,874
|
Re: Speed control
Is the solenoid welded shut? They will go into creep mode.
|
|
|
|
|
10-22-2012, 02:54 PM
|
#3 |
|
Not Yet Wild
Join Date: Oct 2012
Posts: 17
|
Re: Speed control
The solenoid is working I can turn it off and on. The micro switch also ohmed out good. I am wodnering about how to check that ITS module that the bayonet goes thru to vary the speed.
|
|
|
|
|
10-22-2012, 03:32 PM
|
#4 |
|
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,874
|
Re: Speed control
here is the test from the manual
|
|
|
|
|
10-22-2012, 04:04 PM
|
#5 |
|
Not Yet Wild
Join Date: Oct 2012
Posts: 17
|
Re: Speed control
Thanks but I can not open in order to read it. I tried copying to word and can't blow it up due to low resolution..
|
|
|
|
|
10-22-2012, 09:26 PM
|
#6 |
|
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,874
|
Re: Speed control
Did you try just left click it and read it?
|
|
|
|
|
10-23-2012, 05:57 AM
|
#7 |
|
Card Carrying Old Fart
Join Date: Feb 2012
Location: Kentucky
Posts: 706
|
Re: Speed control
|
|
|
|
|
10-23-2012, 07:11 AM
|
#8 |
|
Not Yet Wild
Join Date: Oct 2012
Posts: 17
|
Re: Speed control
Thank you for your help
|
|
|
|
|
10-23-2012, 09:36 AM
|
#9 |
|
Not Yet Wild
Join Date: Oct 2012
Posts: 17
|
Re: Speed control
Is there a reset for creep mode?
|
|
|
|
|
10-23-2012, 10:14 AM
|
#10 |
|
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: Speed control
Flipping the Run/Tow switch to Tow, waiting 30 Seconds and flipping back to run will rest the controller.
But if the problem that put it in the creep mode still exists, it'll just go back into the creep mode. Put the PDS controller into the Diagnostic mode and see if it gives any beep codes. Here is the label on the controller cover in an easier to read format. The text at the bottom of label tell you how to get into diagnostic mode. |
|
|
|
|
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Speed control | Electric Club Car | |||
| speed control bad? | Columbia ParCar | |||
| more speed without sacrificing low speed control | Gas Club Car | |||
| Speed control | Electric EZGO | |||
| G2 Speed Control | Gas Yamaha | |||
Linear Mode
